Indiana Administrative Code
Title 326 - AIR POLLUTION CONTROL DIVISION
Article 20 - HAZARDOUS AIR POLLUTANTS
Rule 20 - Epoxy Resins and Non-Nylon Polyamides
Section 20-1 - Applicability; incorporation by reference of federal standards

Universal Citation: 326 IN Admin Code 20-1

Current through March 20, 2024

Authority: IC 13-17-3-4; IC 13-17-3-11

Affected: IC 13-15; IC 13-17

Sec. 1.

(a) This rule applies to manufacturers of the following products, as provided in 40 CFR 63.520 * of Subpart W, that are major sources of hazardous air pollutants (HAPs) as defined in Section 112(a) of the Clean Air Act:

(1) Basic liquid epoxy resins.

(2) Non-nylon polyamides (also known as wet strength resins).

(b) The air pollution control board incorporates by reference 40 CFR 63, Subpart W*, National Emission Standards for Hazardous Air Pollutants for Epoxy Resins Production and Non-Nylon Polyamides Production.

*These documents are incorporated by reference. Copies may be obtained from the Government Printing Office, 732 North Capitol Street NW, Washington, D.C. 20401 or are available for review and copying at the Indiana Department of Environmental Management, Office of Air Quality, Tenth Floor, 100 North Senate Avenue, Indianapolis, Indiana 46204.

Disclaimer: These regulations may not be the most recent version. Indiana may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.