Illinois Administrative Code
Title 62 - MINING
Part 245 - HYDRAULIC FRACTURING REGULATORY ACT
Subpart I - HIGH VOLUME HORIZONTAL HYDRAULIC FRACTURING PRODUCTION
Section 245.900 - Managing Natural Gas and Hydrocarbon Fluids During Production
Current through Register Vol. 48, No. 12, March 22, 2024
For wells regulated by this Part, permittees shall be responsible for minimizing the emissions associated with venting of hydrocarbon fluids and natural gas during the production phase to safely maximize resource recovery and minimize releases to the environment (Section 1-75(e)(4) of the Act).
a) Except for wells covered by subsection (i), sand traps, surge vessels, separators, and tanks must be employed as soon as practicable during cleanout operations to safely maximize resource recovery and minimize releases to the environment. (Section 1-75(e)(4)(B) of the Act)
b) Except for wells covered by subsection (i), recovered hydrocarbon fluids must be routed into storage vessels. (Section 1-75(e)(4)(A) of the Act)
c) Except for wells covered by subsection (i), recovered natural gas must be:
d) If the permittee establishes that it is technically infeasible or economically unreasonable to minimize emissions associated with the venting of hydrocarbon fluids and natural gas during production using the methods specified in subsections (b) and (c), the Department, in consultation with the Agency as the Department deems appropriate, shall require the permittee to capture and direct any natural gas produced during the production phase to a flare.
e) In order to establish technical infeasibility under subsection (d), the permittee must demonstrate to the Department's satisfaction, for each well site on an annual basis, that taking the actions listed in subsections (b) and (c) are not cost effective based on a well site-specific analysis, and that the technology listed in subsections (b) and (c) does not exist, cannot be installed at the well site, will not achieve the result intended, or is otherwise unavailable or ineffective. The permittee claiming economic unreasonableness shall provide the Department with the following:
f) Any flare used pursuant to this Section shall be equipped with an auto-igniter and a reliable continuous ignition source over the duration of production. The manufacturer's specifications for all flares must be provided to the Department before operation of the flare begins, and the Department shall post the specifications to its website.
g) Permittees that use a flare during the production phase for operations other than emergency conditions shall visually inspect or monitor the flare on a regular basis to insure it is operating properly. The permittee shall file an updated well site-specific analysis annually with the Department on a form prescribed by the Department in consultation with the Agency. The analysis shall:
h) On or after July 1, 2015, all flares used under this Section shall:
i) For each wildcat well, delineation well, or low pressure well, permittees shall be responsible for minimizing the emissions associated with venting of hydrocarbon fluids and natural gas during the production phase by capturing and directing the emissions to a flare during the production phase, except in conditions that may result in a fire hazard or explosion, or where high heat emissions from a flare may negatively impact waterways. Flares shall be used during the production phase. (Section 1-75(e)(8) of the Act)