Illinois Administrative Code
Title 35 - ENVIRONMENTAL PROTECTION
Part 739 - STANDARDS FOR THE MANAGEMENT OF USED OIL
Subpart F - STANDARDS FOR USED OIL PROCESSORS
Section 739.155 - Analysis Plan
Universal Citation: 35 IL Admin Code § 739.155
Current through Register Vol. 48, No. 38, September 20, 2024
An owner or operator of a used oil processing or re-refining facility must develop and follow a written analysis plan describing the procedures that will be used to comply with the analysis requirements of Section 739.153 and, if applicable, Section 739.172. The owner or operator must keep the plan at the facility.
a) Rebuttable presumption for used oil in Section 739.153. At a minimum, the plan must specify the following:
1) Whether sample analyses or knowledge of
the halogen content of the used oil will be used to make this
determination;
2) If sample
analyses are used to make this determination, the following requirements must
be fulfilled:
A) The sampling method used to
obtain representative samples to be analyzed. A representative sample may be
obtained using either of the following:
i)
One of the sampling methods in Appendix I of 35 Ill. Adm. Code 721;
or
ii) A method shown to be
equivalent under 35 Ill. Adm. Code
720.120 and
720.121;
B) The frequency of sampling to be
performed, and whether the analysis will be performed on-site or off-site;
and
C) The methods used to analyze
used oil for the parameters specified in Section 739.153; and
3) The type of information that
will be used to determine the halogen content of the used oil.
b) On-specification used oil fuel in Section 739.172. At a minimum, the plan must specify the following if Section 739.172 is applicable:
1) Whether sample analyses or
other information will be used to make this determination;
2) If sample analyses are used to make this
determination, the following must be specified:
A) The sampling method used to obtain
representative samples to be analyzed. A representative sample may be obtained
using either of the following:
i) One of the
sampling methods in Appendix I of 35 Ill. Adm. Code 721; or
ii) A method shown to be equivalent under 35
Ill. Adm. Code
720.120 and
720.121;
B) Whether used
oil will be sampled and analyzed prior to or after any processing;
C) The frequency of sampling to be performed,
and whether the analysis will be performed on-site or off-site; and
D) The methods used to analyze used oil for
the parameters specified in Section 739.172; and
3) The type of information that will be used
to make the on-specification used oil fuel determination.
Disclaimer: These regulations may not be the most recent version. Illinois may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.