Illinois Administrative Code
Title 35 - ENVIRONMENTAL PROTECTION
Part 307 - SEWER DISCHARGE CRITERIA
Subpart CQ - COPPER FORMING
Section 307.7800 - General Provisions
Universal Citation: 35 IL Admin Code ยง 307.7800
Current through Register Vol. 48, No. 38, September 20, 2024
a) Applicability
1) This Subpart CQ applies to
discharges resulting from the manufacture of formed copper and copper alloy
products. The forming operations covered are hot rolling, cold rolling,
drawing, extrusion, and forging. This Subpart CQ does not regulate the forming
of precious metals. (See Subpart CT.) The casting of copper and copper alloys
is not covered by this Subpart CQ. (See Subpart CM.)
2) The discharge allowance for drawing spent
lubricant of 40 CFR
468.14(c) and
468.15(c),
incorporated by reference in Section
307.7801(d)(1),
applies only to those plants that actually discharge the drawing spent
lubricant waste stream at copper forming sites. No discharge allowance is
applicable or allowable when these wastewaters are hauled off-site for disposal
or are otherwise not discharged at copper forming sites.
b) General Definitions. The Board incorporates by reference 40 CFR 468.02 (2003). This incorporation includes no later amendments or editions.
c) Monitoring Requirements. The Board incorporates by reference 40 CFR 468.03 (2003). This incorporation includes no later amendments or editions.
d) Compliance Dates. The Board incorporates by reference 40 CFR 468.04 (2003). This incorporation includes no later amendments or editions.
Disclaimer: These regulations may not be the most recent version. Illinois may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
