Illinois Administrative Code
Title 35 - ENVIRONMENTAL PROTECTION
Part 1422 - DESIGN AND OPERATION OF FACILITIES
Subpart A - GENERAL PROVISIONS
Section 1422.105 - PIMW Permit Application Contents
Universal Citation: 35 IL Admin Code ยง 1422.105
Current through Register Vol. 48, No. 38, September 20, 2024
a) A permit application for a PIMW treatment, storage, or transfer operation must contain:
1) Legal description of the
facility's location.
2) Maps and
floor plans showing the location of the facility, the facility boundary, and
the location of all units included in the facility.
3) Process flow diagrams or schematic
drawings showing the flow of waste through the facility. The diagrams or
drawings must show the locations of residuals, recycled streams, sample points,
equipment, and process monitoring devices. Equipment must be labeled on the
process flow diagram to correspond to an equipment number.
4) Written description of the facility or
facility operations with supporting documentation describing the procedures and
plans that will be used at the facility to comply with the requirements of 35
Ill. Adm. Code Subtitle M and any other applicable Board rules. The description
must include:
A) The type of waste management
units, and the types and volumes of waste;
B) The overall process to be used for
treating or storing PIMW and the anticipated performance of the
process;
C) In detail, the major
activities at the facility, such as transfer, storing, screening, weighing,
processing, and treatment (including the number of units) of PIMW;
D) The operations for initial facility
startup, daily startup, and scheduled and unscheduled shutdowns;
E) The days and hours of operation;
F) The operating parameters for the treatment
units;
G) The safety and monitoring
equipment for the treatment units;
H) A cleaning and disinfection plan
describing the daily cleanup procedures, including the methods to disinfect
emptied reusable PIMW containers, transport vehicles, and facility surfaces and
equipment contaminated with PIMW;
I) The methods to control: emissions of odors
and aerosols generated, including all supporting design and engineering data;
dust, noise, litter, and vectors; and handling and storage;
J) The methods to treat, transfer, or dispose
of residual wastes generated from the operation of the facility;
K) Adequacy of the utilities to operate the
facility and to respond to emergency situations;
L) Numbers and duties of employees directly
responsible for the operation of the site or facility; and
M) Location and type of security devices to
prevent unauthorized access.
5) A waste screening plan that describes
procedures to be used to identify and prevent the acceptance of unauthorized
wastes.
6) Description of
procedures to be used for inspection, contingency, recordkeeping, and closure
plans as required by this Part.
7)
For a facility at which the owner or operator is required to conduct either
Initial Efficacy Tests or Periodic Verification Tests, a written description of
procedures to be used for recordkeeping, classifying residuals, and collecting
data for the Document of Initial Efficacy Demonstration and Correlating
Periodic Verification Demonstration.
b) If the applicant believes that any of the documentation or information listed in subsection (a) is not applicable for reasons such as irrelevancy, the application must include the reasons in support of that belief.
Disclaimer: These regulations may not be the most recent version. Illinois may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
