Idaho Administrative Code
Title IDAPA 16 - Health and Welfare, Department of
Rule 16.02.14 - CONSTRUCTION AND OPERATION OF PUBLIC SWIMMING POOLS
Section 16.02.14.270 - WALL INLETS
Universal Citation: ID Admin Code 16.02.14.270
Current through September 2, 2024
01. General Inlet Requirements. Except as otherwise provided in this rule, inlets must:
a. Be rounded and smooth and installed not less than eighteen (18) inches below the normal operating level and located to produce a uniform circulation, without the existence of dead spots; and
b. Not extend from the pool wall or floor so as to create a hazard.
02. Wall Inlet Requirements. If wall inlets are used, there must:
a. Be at a minimum of one (1) per each six hundred (600) square feet of pool surface area.
b. Be a minimum of two (2) inlets. In case of a shallow pool, the Director's designee may grant an exception to this requirement if inlets cannot be installed at the depth otherwise required.
Effective March 15, 2022
Disclaimer: These regulations may not be the most recent version. Idaho may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
