Hawaii Administrative Rules
Title 11 - DEPARTMENT OF HEALTH
Subtitle 1 - GENERAL DEPARTMENTAL PROVISIONS
Chapter 264 - HAZADOUS WASTE MANAGEMENT STANDARDS FOR OWNERS AND OPERATERS OF HAZADOUS WASTE TREATMENT, STORAGE, AND DISPOSAL FACILITIES
Appendix IV to Part 264 - Cochran's Approximation to the Behrens- Fisher Students' T-Test

Using all the available background data (nb readings), calculate the background mean (Xb ) and background variance (sb3). For the single monitoring well under investigation (nm reading), calculate the monitoring mean (Xm ) and monitoring variance (sm2 ).

For any set of data (X1 , X2 ,..., Xn) the mean is calculated by:

Click Here To View Image

and the variance is calculated by:

Click Here To View Image

where "n" denotes the number of observations in the set of data.

The t-test uses these data summary measures to calculate a t-statistic (t* ) and a comparison t-statistic (tc) . The t* value is compared to the tc value and a conclusion reached as to whether there has been a statistically significant change in any indicator parameter.

The t-statistic for all parameters except pH and similar monitoring parameters is:

Click Here To View Image

Click Here To View Image

If the value of this t-statistic is negative then there is no significant difference between the monitoring data and background data. It should be noted that significantly small negative values may be indicative of a failure of the assumption made for test validity or errors have been made in collecting the background data.

The t-statistic (tc) , against which t* will be compared, necessitates finding tb and tm from standard (one-tailed) tables

where,

tb = t-tables with (nb-1) degrees of freedom, at the 0.05 level of significance.

tm = t-tables with (nm-1) degrees of freedom, at the 0.05 level of significance.

Finally, the special weightings Wb and Wmare defined as:

Click Here To View Image

and so the comparison t-statistic is:

Click Here To View Image

The t-statistic (t*) is now compared with the comparison t-statistic (tc) using the following decision-rule:

If t* is equal to or larger than tc , then conclude that there most likely has been a significant increase in this specific parameter.

If t* is less than tc , then conclude that most likely there has not been a change in this specific parameter.

The t-statistic for testing pH and similar monitoring parameters is constructed in the same manner as previously described except the negative sign (if any) is discarded and the caveat concerning the negative value is ignored. The standard (two-tailed) tables are used in the construction tc for pH and similar monitoring parameters.

If t* is equal to or larger than tc, then conclude that there most likely has been a significant increase (if the initial t* had been negative, this would imply a significant decrease). If t* is less than tc , then conclude that there most likely has been no change.

A further discussion of the test may be found in "Statistical Methods" (6th Edition, Section 4.14) by G. W. Snedecor and W. G. Cochran, or "Principles and Procedures of Statistics" (1st Edition, Section 5.8) by R. G. D. Steel and J. H. Torrie.

Standard T-Tables 0.05 Level of Significance

Adopted from Table III of "Statistical Tables for Biological, Agricultural, and Medical Research" (1947, R. A. Fisher and F. Yates).