Delaware Administrative Code
Title 2 - Transportation
2000 - Department of Transportation
2400 - Division of Transportation Solutions
2402 - Manual on Uniform Traffic Control Devices (MUTCD)
Part 2 - Signs
Chapter 2B - REGULATORY SIGNS, BARRICADES, AND GATES
Section 2B.04 - Right-of-Way at Intersections
Current through Register Vol. 28, No. 3, September 1, 2024
Support:
01 (DE Revision) § 4131 of Title 21 of the Delaware Code establishes the right-of-way rule at intersections having no regulatory traffic control signs such that the driver of a vehicle approaching an intersection must yield the right-of-way to any vehicle or pedestrian already in the intersection. When two vehicles approach an intersection from different streets or highways at approximately the same time, the right-of-way rule requires the driver of the vehicle on the left to yield the right-of-way to the vehicle on the right. The right-of-way can be modified at through streets or highways by placing YIELD (R1-2) signs (see Sections 2B.08 and 2B.09) or STOP (R1-1) signs (see Sections 2B.05 through 2B.07) on one or more approaches.
Guidance:
02 Engineering judgment should be used to establish intersection control. The following factors should be considered:
03 YIELD or STOP signs should be used at an intersection if one or more of the following conditions exist:
04 In addition, the use of YIELD or STOP signs should be considered at the intersection of two minor streets or local roads where the intersection has more than three approaches and where one or more of the following conditions exist:
05 YIELD or STOP signs should not be used for speed control.
Support:
06 Section 2B.07 contains provisions regarding the application of multi-way STOP control at an intersection.
Guidance:
07 Once the decision has been made to control an intersection, the decision regarding the appropriate roadway to control should be based on engineering judgment. In most cases, the roadway carrying the lowest volume of traffic should be controlled.
08 A YIELD or STOP sign should not be installed on the higher volume roadway unless justified by an engineering study.
Support:
09 The following are considerations that might influence the decision regarding the appropriate roadway upon which to install a YIELD or STOP sign where two roadways with relatively equal volumes and/or characteristics intersect:
Standard:
10 Because the potential for conflicting commands could create driver confusion, YIELD or STOP signs shall not be used in conjunction with any traffic control signal operation, except in the following cases:
11 Except as provided in Section 2B.09, STOP signs and YIELD signs shall not be installed on different approaches to the same unsignalized intersection if those approaches conflict with or oppose each other.
12 Portable or part-time STOP or YIELD signs shall not be used except for emergency and temporary traffic control zone purposes.
13 A portable or part-time (folding) STOP sign that is manually placed into view and manually removed from view shall not be used during a power outage to control a signalized approach unless the maintaining agency establishes that the signal indication that will first be displayed to that approach upon restoration of power is a flashing red signal indication and that the portable STOP sign will be manually removed from view prior to stop-and-go operation of the traffic control signal.
Option:
14 A portable or part-time (folding) STOP sign that is electrically or mechanically operated such that it only displays the STOP message during a power outage and ceases to display the STOP message upon restoration of power may be used during a power outage to control a signalized approach.
Support:
15 Section 9B.03 contains provisions regarding the assignment of priority at a shared-use path/roadway intersection.