California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 7 - General Industry Safety Orders
Group 8 - Points of Operation and Other Hazardous Parts of Machinery
Article 72 - Plastic Processing Machinery
Section 4600 - Injection Molding Machine
Current through Register 2024 Notice Reg. No. 38, September 20, 2024
Every injection molding machine shall be guarded:
(a) By a sliding gate guard so designed and installed that it interposes a barrier between the dies and the operator before the dies can close and shall be so arranged that if the gate can be opened during the die closing cycle the die motion will be immediately stopped by the opening of the gate.
The sliding gate guard shall extend over the top and to each side of the dies to prevent the operator from placing his/her hands between the dies while they are closing. The danger zone on the side of the machine opposite the operator's working position shall also be guarded, or
(b) By two-handed constant pressure devices or controls which require the simultaneous use of both the operator's hands during the entire die closing cycle.
1. Amendment filed 4-25-86; effective thirtieth day thereafter (Register 86, No. 17).
Note: Authority cited: Section 142.3, Labor Code. Reference: Section 142.3, Labor Code.
