California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 7 - General Industry Safety Orders
Group 3 - General Plant Equipment and Special Operations
Article 21 - Use, Care, and Protection of Abrasive Wheels
- Section 3575 - Scope and Definitions
- Section 3576 - General Machine Requirements
- Section 3577 - Protection Devices
- Section 3578 - Permissible Wheel Exposure for Periphery Grinding
- Section 3579 - Flanges-General Requirement
- Section 3580 - Mounting
- Section 3581 - Speed. [Repealed]
- Section 3582 - Storage
- Figure A-15 through A-22
- Section 3583 - Portable Abrasive Wheels
- Table A-1 - Minimum Dimensions for Straight Relieved Flanges
- Table A-2 - Minimum Dimensions for Straight Unrelieved Flanges for Wheels with Threaded Inserts or Projecting Studs
- Table A-3 - Minimum Dimensions for Straight Adaptor Flange-for Organic Bonded Wheels over 1 1/4 Inch Thick*
- Table A-4 - Minimum Dimensions for Straight Flanges-for Mechanical Grinders 12,500 S.F.P.M. To 16,500 S.F.P.M
- Table A-5 - Minimum Dimensions for Straight Flanges Used as Wheel Sleeves for Precision Grinding Only
- Table A-6 - Guide for Construction of Band Type Guards Maximum Wheel Speed 7000 Sfpm
- Table A-7 through A-18
- Appendix A
- Appendix B
- Appendix C
- Appendix D
- Appendix E
- Appendix F
- Appendix G
Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
