California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 7 - General Industry Safety Orders
Group 13 - Cranes and Other Hoisting Equipment
Article 98 - Operating Rules
- Section 4990 - Scope
- Section 4991 - Travel
- Section 4991.1 - Ground Conditions
- Section 4992 - Booms
- Section 4993 - Swing
- Section 4993.1 - Work Area Control
- Section 4994 - Hoisting
- Section 4995 - Riding Loads on Derricks, Hoists, or Cranes
- Section 4996 - Driver's Position
- Section 4997 - Fire Extinguisher
- Section 4998 - Refueling
- Section 4999 - Handling Loads
- Section 5000 - Limit Switches
- Section 5001 - Signals - General Requirements
- Plate I - Recommended Hand Signals for Controlling Crane Operations
- Section 5001.1 - Signals - Radio, Telephone or Other Electronic Transmission of Signals
- Section 5001.2 - Signals - Voice Signals - Additional Requirements
- Section 5001.3 - Signal Person Qualifications - Supplemental Requirements for Cranes and Derricks in Construction
- Section 5002 - Overhead Loads
- Section 5003 - Provisions for Preventing Accidents in the Area of High-Voltage Lines
- Section 5003.1 - Power Line Safety (up to and Including 350kv) - Equipment Operations
- Section 5003.2 - Power Line Safety (over 350kv)
- Section 5003.3 - Power Line Safety (All Voltages) - Equipment Operations Closer than the Table a Zone
- Section 5003.4 - Power Line Safety - While Traveling Under or near Power Lines with NO Load
- Section 5004 - Crane or Derrick Suspended Personnel Platforms
- Section 5005 - Work near Transmitter Towers
- Section 5006 - Crane and Hoisting Equipment Operators-Qualifications
- Section 5006.1 - Mobile Crane and Tower Crane - Operator Qualifications and Certification (Applicable to Cranes in General Industry Only)
- Section 5006.2 - Operator Training, Certification, and Evaluation for Cranes and Derricks in Construction
- Section 5008 - Operating Practices
- Section 5008.1 - Operation
- Section 5009 - Floor-Operated Cranes
- Section 5010 - Assembly/Disassembly - Selection of Manufacturer or Employer Procedures
- Section 5010.1 - Assembly/Disassembly - General Requirements (Applies to All Assembly and Disassembly Operations)
- Section 5010.2 - Disassembly - Additional Requirements for Dismantling of Booms and Jibs (Applies to Both the Use of Manufacturer Procedures and Employer Procedures)
- Section 5010.3 - Assembly/Disassembly - Employer Procedures - General Requirements
- Section 5010.4 - Power Line Safety (up to and Including 350kv) - Assembly and Disassembly
- Section 5011 - Fall Protection - Supplemental/Specific Requirements for Cranes
- Section 5012 - Training - Supplemental Requirements for Cranes in Construction
Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
