California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 5 - Electrical Safety Orders
Group 1 - Low-Voltage Electrical Safety Orders
Article 56 - MOTORS, MOTOR CIRCUITS AND CONTROLLERS
MOTOR CONTROLLERS
Section 2530.81 - General

Universal Citation: 8 CA Code of Regs 2530.81

Current through Register 2024 Notice Reg. No. 38, September 20, 2024

This Section, "Motor Controllers," is intended to require suitable controllers for all motors.

(a) Definition. For definition of "Controller," see Article 1. For the purpose of this Article, the term "Controller" includes any switch or device normally used to start and stop a motor.

(b) Stationary Motor of 1/8 Horsepower or Less. For a stationary motor rated at 1/8 horsepower or less that is normally left running and is so constructed that it cannot be damaged by overload or failure to start, such as clock motors and the like, the branch circuit protective device shall be permitted to serve as the controller.

(c) Portable Motor of 1/3 Horsepower or Less. For a portable motor rated at 1/3 horsepower or less, the controller shall be permitted to be an attachment plug and receptacle.

(Title 24, Part 3, Section 430-81.)

1. Editorial correction filed 11-2-83 (Register 83, No. 45).

Note: Authority cited: Section 142.3, Labor Code. Reference: Section 142.3, Labor Code; and Section 18943(c), Health and Safety Code.

Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.