California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 4 - Construction Safety Orders
Article 14 - Construction Hoists
Section 1604.30 - Revision of American National Standards Referred to in this Document

Universal Citation: 8 CA Code of Regs 1604.30

Current through Register 2024 Notice Reg. No. 38, September 20, 2024

(a) When the following American National Standards referred to in this document are superseded by a revision approved by the American National Standards Institute, Inc., the revision shall apply:

(1) American National Standard Building Code Requirements for Reinforced Concrete, A89.1-1972 (ACI 318-71).

(2) American National Standard Specification for Low and Intermediate Tensile Strength Carbon Steel Plates of Structural Quality, G24.2-1972 (ASTM A283-70a).

(3) American National Standard Specification for Quenched and Tempered Alloy Steel Bolts or Structural Steel Joints, G24.19-1972 (ASTM A490-71).

(4) American National Standard Specification for Low Carbon Steel Externally and Internally Threaded Standard Fasteners, G28.5-1969 (ASTM A307.68).

(5) American National Standard Specification for High-Strength Bolts for Structural Steel Joints, including Suitable Nuts and Plain Hardened Washers, G38.6-1972 (ASTM A325-71a).

(6) American National Standard Specification for Structural Steel, G41.5-1970 (ASTM A325-69).

(7) American National Standard Specification for Steel Structural Rivets, G42.2-1968 (ASTM A502.65).

(8) American National Standard Specification for Mild to Medium Strength Carbon Steel Castings for General Application, G50.1-1972 (ASTM A27-71).

(9) American National Standard Specification for Carbon Steel Forgings for General Industrial Use, G55.20-1969 (ASTM A235-67).

(10) American National Standard Methods of Static Tests of Timbers in Structural Sizes, 04.2-1969 (ASTM D198-67).

(11) American National Standard Methods for Establishing Structural Grades for Visually Graded Lumber, 04.3-1969 (ASTM D245-68T).

(12) American National Standard Safety in Welding and Cutting, Z49.1-1973.

Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.