California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 17 - Mine Safety Orders
Article 35 - Mine Shafts
Section 7112 - Shaft Work-Major Repair
Universal Citation: 8 CA Code of Regs 7112
Current through Register 2024 Notice Reg. No. 38, September 20, 2024
(a) To prevent injury to men and keep materials from falling down the shaft while extensive repair work is carried on, the following precautions shall be taken:
(1) A substantially constructed bulkhead
shall be secured in place in the compartment where the repair operations are
carried on, and as close below where the men are working as is
practical.
(2) (19-77) When the
shaft conveyance is lowered to the working place, it shall be stopped at least
15 feet above the working place and shall be held there until a further signal
is given by the repair crew.
Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
