California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 14 - Petroleum Safety Orders-Drilling and Production
Article 37 - Oil Well Pumping Machinery and Equipment
Section 6633 - Attractive Nuisance Guards: Well-Pumping Units

Universal Citation: 8 CA Code of Regs 6633

Current through Register 2024 Notice Reg. No. 38, September 20, 2024

(a) Where attractive nuisance guards are provided in addition to guards required by the Division, they shall conform to the following:

(1) In case of single well-pumping units, at least one (1) gate, door, or other opening shall be provided in the motor or engine end of the guard to provide safe access and exit for employees when required to go within the confines of the attractive nuisance guard.

(2) In the case of multiple well-pumping units enclosed by such guards, at least one (1) gate, door, or other opening shall provide safe access and exit for employees. Where the hazard justifies, the Division may require two (2) or more gates, doors, or other openings, so located with respect to each other that they will provide alternate means of escape in case of an emergency.

(b) The minimum vertical clearance through doorways, gateways, or passageways in attractive nuisance guards shall not be less than six feet six inches (6' 6"). A clear and unobstructed passageway through the doorways, gateways or other openings shall be as required in the General Industry Safety Orders, Sections 3224, 3225, and 3235.

(c) When only one (1) door, gate or other opening is provided in the attractive nuisance guards, as required in subsection (a)(1) of this section, a clear and unobstructed passageway of at least two feet (2') wide shall be provided and maintained between the attractive nuisance guards and the guards installed in accordance with the General Industry Safety Orders, Group 6, for moving parts of machinery.

(d) When a door, gate or passageway is provided in the well end of the attractive nuisance guard, in addition to the one required in the motor or engine end of the guard, and the space between the guards for the pitmans and cranks of pumping units and the attractive nuisance guards is railed, barricaded, or otherwise guarded to prevent its use as a passageway, the two-foot (2') clearance between these guards will not be required when provision is made for employees to perform lubricating duties on the pumping unit from a location outside the guards.

(e) When the access/egress openings through the attractive nuisance fencing guard are blocked at the well location, additional egress shall be provided away from the well head area.

1. New section filed 5-8-95; operative 6-7-95 (Register 95, No. 19).

Note: Authority cited: Section 142.3, Labor Code. Reference: Section 142.3, Labor Code.

Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.