California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 13 - Logging and Sawmill Safety Orders
Article 5 - Falling and Bucking
Section 6285 - Tree Jacking

Universal Citation: 8 CA Code of Regs 6285

Current through Register 2024 Notice Reg. No. 38, September 20, 2024

(a) Hydraulic tree jacks purchased after January 1, 1980, shall be equipped with:

(1) An operable load check valve, velocity fuse or equivalent device. When hoses are used with a jack, the device shall be installed between the ram and the first piece of hose out from the jack.

(2) An operable pressure gauge.

(b) If two or more tree jacks are used and operated with one pump, a one way flow valve shall be used to isolate the hydraulic fluid from one jack to another jack, should failure occur in the system.

(c) Hydraulic tree jacks shall have enough lift power and be of sufficient in number for the trees to be jacked and felled.

(d) A metal plate shall be placed between the ram and the saw cuts when using a hydraulic jack. The metal plate or pad shall be of sufficient area and have a surface design to prevent the plate or pad from sinking into the wood or slipping.

(e) If the faller is pumping the jack at the base of the tree, wedges shall be used as a follow-up method while using tree jacks. The wedges shall be progressively moved in as the tree is jacked.

Note: Authority cited: Section 142.3, Labor Code. Reference: Section 142.3, Labor Code.

Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.