California Code of Regulations
Title 8 - Industrial Relations
Division 1 - Department of Industrial Relations
Chapter 4 - Division of Industrial Safety
Subchapter 13 - Logging and Sawmill Safety Orders
Article 16 - Veneer and Plywood Plants
Section 6382 - Veneer Presses

Universal Citation: 8 CA Code of Regs 6382

Current through Register 2024 Notice Reg. No. 38, September 20, 2024

(a) Hot-press hoists shall be provided with a braking and holding mechanism which will operate automatically in case of failure of the lifting chains or cables.

(b) On a hot-press equipped with an automatic charger, an electrically interlocked gate or chain shall be provided across the opening between the charger and the press which, when opened, will open the circuit to prevent the charger from moving.

(c) Where two workers are employed in loading the press, closing control devices shall be provided within reach of each work station. These devices shall interconnect so that activation of both controls is required to operate the press. A quick-opening device shall be provided at each work station on the press hoist platform.

Note: Authority cited: Section 142.3, Labor Code. Reference: Section 142.3, Labor Code.

Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.