California Code of Regulations
Title 21 - Public Works
Division 2.5 - Division of Aeronautics (Department of Transportation)
Table 2 - Runway Safety Area Dimensions
Universal Citation: 21 CA Code of Regs 2
Current through Register 2024 Notice Reg. No. 38, September 20, 2024
|
Airplane Design Group |
||||||
| DIM4 | ||||||
| I5 | I | II | III | IV | ||
| Runway Safety | ||||||
| Area Width | A | 120 ft | 120 ft | 150 ft | 300 ft | 500 ft |
| Runway Safety | ||||||
| Area Length beyond | B | 240 ft | 240 ft | 300 ft | 600 ft | 1000 ft |
| end of Runway6 | ||||||
4 These letters correspond to the dimensions on Figure 2.
5 These dimensional standards pertain to facilities for small airplanes exclusively. "Small airplane" means an airplane of 12,500 pounds or less maximum certificated takeoff weight.
6 The runway safety area length begins at each runway end if there is no stopway provided. When stopway is provided, the length begins at the stopway end.
Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
