California Code of Regulations
Title 14 - Natural Resources
Division 1.5 - Department of Forestry and Fire Protection
Chapter 4 - Forest Practices
Subchapter 7 - Administration
Article 5 - Standardized Stocking Sampling Procedures
Section 1072.7 - Combination Stocking Sampling Procedure

Universal Citation: 14 CA Code of Regs 1072.7
Current through Register 2024 Notice Reg. No. 38, September 20, 2024

The procedure is used where the silvicultural Rules of each forest District and the Act allow the Stocking Standards to be met through combination of point count and basal area. The following procedure shall be used to determine if these Stocking Standards have been met: At each plot center the Timber Owner or agent thereof shall check for either basal area or Countable Trees. The same basal area factor shall be used on all plots in the sample. If the plot is not stocked with Countable Trees as specified in 14 CCR § 1072.5, it shall be necessary to sample for Countable Trees as specified in 14 CCR § 1072.6.

1. Change without regulatory effect amending section filed 10-31-2017 pursuant to section 100, title 1, California Code of Regulations (Register 2017, No. 44).

Note: Authority cited: Sections 4551 and 4587, Public Resources Code. Reference: Section 4587, Public Resources Code.

Disclaimer: These regulations may not be the most recent version. California may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.