Arizona Administrative Code
Title 18 - ENVIRONMENTAL QUALITY
Chapter 9 - DEPARTMENT OF ENVIRONMENTAL QUALITY - WATER POLLUTION CONTROL
Article 3 - AQUIFER PROTECTION PERMITS - GENERAL PERMITS
Part A - GENERAL PROVISIONS
Section R18-9-A302 - Point of Compliance
Universal Citation: AZ Admin Code R 18-9-A302
Current through Register Vol. 30, No. 38, September 20, 2024
The point of compliance is the point at which compliance with Aquifer Water Quality Standards is determined.
1. Except as provided in this Section or as stated in a specific general permit, the applicable point of compliance at a facility operating under a general permit is a vertical plane downgradient of the facility that extends through the uppermost aquifers underlying that facility.
2. The point of compliance is the limit of the pollutant management area.
a. The pollutant management area is the
horizontal plane of the area on which pollutants are or will be
placed.
b. If a facility operating
under a general permit is located within a larger pollutant management area
established under an individual permit issued to the same person, the point of
compliance is the applicable point of compliance established in the individual
permit.
Disclaimer: These regulations may not be the most recent version. Arizona may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
