Alaska Administrative Code
Title 8 - Labor and Workforce Development
Part 4 - Occupational Safety and Health Division
Chapter 80 - Boiler and Pressure Vessel Construction Code
Article 1 - Boiler and Pressure Vessel Construction Code
8 AAC 80.060 - Inspection and stamping
Universal Citation: 8 AK Admin Code 80.060
Current through February 27, 2024
(a) Upon completion of installation, a boiler or unfired pressure vessel covered by AS 18.60.180 must be inspected by a deputy inspector or special inspector and identified by state vessel number assigned by the department.
(b) The state vessel number shall be affixed as follows:
(1)
except as provided in (2) of this subsection, a steel boiler or unfired
pressure vessel will be stamped, preferably on the nameplate, with at least
five-sixteenths-inch numbers; the stamping must be plainly visible and easily
read;
(2) paint marker pens may be
used if they are designed to make notations that are permanent and readable;
the state vessel number must be placed above or below the manufacturer's
information nameplate;
(3) during
the initial inspection and each subsequent periodic inspection,
(A) the responsible inspector shall affix an
inspection tag provided by the department;
(B) the inspection tag must set out
(i) the state vessel number;
(ii) the name of the responsible
inspector;
(iii) the responsible
inspector's identification number as it appears on the card issued under
8
AAC 80.040, if the responsible inspector is a special
inspector; and
(iv) the month and
year in which the inspection was performed; and
(C) the inspection tag must be replaced at
each subsequent periodic inspection.
Authority:AS 18.60.180
Disclaimer: These regulations may not be the most recent version. Alaska may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
