Alabama Administrative Code
Title 440 - ALABAMA BOARD OF HEATING, AIR CONDITIONING AND REFRIGERATION CONTRACTORS
Chapter 440-X-5 - MINIMUM STANDARDS FOR INSTALLATION, SERVICE, AND REPAIR OF HEATING, AIR CONDITIONING OR REFRIGERATION SYSTEMS BY CERTIFIED CONTRACTORS
Section 440-X-5-.02 - Minimum Standards For Installation, Service Or Repair Of Residential And Commercial Heating And Air Conditioning, And Commercial Refrigeration

Universal Citation: AL Admin Code R 440-X-5-.02

Current through Register Vol. 42, No. 11, August 30, 2024

(1) Pursuant to Section 34-31-2 l(g), Code of Ala. 1975, the Board adopts the following minimum standards for the installation, service or repair of residential heating and air conditioning system, and all certified heating and air conditioning contractors shall comply with the minimum standards required by:

(a) ACCA/Manual J as described in Load Calculation for Residential Winter and Summer Air Conditioning;

(b) ACCA/Manual D as described in Duct Design for Residential Winter and Summer Air Condition and Equipment Selection;

(c) International Residential Code; including appendices;

(d) International Fuel Gas Code;

(e) NFPA 70 National Electrical Code;

(f) NAIMA Fibrous Glass Duct Construction;

(g) SMACNA HVAC Duct Construction Standards, Metal and Flexible

(h) ACCA, Trane, or equivalent ductulators;

(i) NASLCA Contractors Guide to Business, Law and Project Management

(j) Brand specific manufacturers installation instructions;

(k) Any minimum standards required and described by applicable local, State, and Federal codes or ordinances, as well as any and all applicable Alabama agencies, Board's and Commissions' rules and regulations. Where there is conflict between the minimum standards adopted by the Board and the applicable local, State, or Federal codes or ordinances or any applicable Alabama agency, Board or Commission's, rules and regulations, the most restrictive will govern;

(l) ADC Flexible Air Duct Standards.

(2) Pursuant to Section 34-31-2 l(g), Code of Ala. 1975, the Board adopts the following minimum standards for the installation, service or repair of commercial heating and air conditioning system, and all certified heating and air conditioning contractors shall comply with the minimum standards required by:

(a) ACCA/Manual N as described in Load Calculation for Commercial Summer and Winter Air Conditioning;

(b) ACCA/Manual Q as described in Low Pressure, Low Velocity, Duct System Design;

(c) International Mechanical Code; including appendices;

(d) International Fuel Gas Code and appendices;

(e) NFPA 70 National Electrical Code;

(f) ASHRAE Standard 15-2019 as described in Safety Standard for Mechanical Refrigeration;

(g) NAIMA Fibrous Glass Duct Construction;

(h) SMACNA HVAC Duct Construction Standards, Metal

(i) ACCA, Trane, or equivalent ductulators;

(j) NASLCA Contractors Guide to Business, Law and project management

(k) Brand specific manufacturers installation instructions;

(l) Any minimum standards required and described by applicable local, State, and Federal codes or ordinances, as well as any and all applicable Alabama agencies, Board's and Commissions' rules and regulations. Where there is conflict between the minimum standards adopted by the Board and the applicable local, State, or Federal codes or ordinances or any applicable Alabama agency, Board or Commission's, rules and regulations, the most restrictive will govern.

(m) ADC Flexible Air Duct Standards

(3) Pursuant to Section 34-31-21 {g}, Code of Ala. 1975, the Board adopts the following minimum standards for the installation, service or repair of commercial refrigeration systems, and all certified refrigeration contractors shall comply with the minimum standards required by:

(a) International Mechanical Code; including appendices;

(b) NFPA 70 National Electrical Code;

(c) ASHRAE Standard 15-2019 as described in Safety Standard for Mechanical Refrigeration;

(d) NASLCA Contractors Guide to Business, Law and Project Management;

(e) Brand specific manufacturers installation instructions;

(f) Any minimum standards required and described by applicable local, State, and Federal codes or ordinances, as well as any and all applicable Alabama agencies, Board's and Commissions' rules and regulations. Where there is conflict between the minimum standards adopted by the Board and the applicable local, State, or Federal codes or ordinances or any applicable Alabama agency, Board or Commission's, rules and regulations, the most restrictive will govern.

Previous Rule .01 was renumbered .02 as per certification published November 30, 2022; effective January 14, 2023.

Author: Jeffrey Becraft

Statutory Authority: Code of Ala. 1975, § 34-31-21(g).

Disclaimer: These regulations may not be the most recent version. Alabama may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.