Pipeline and Hazardous Materials Safety Administration June 2005 – Federal Register Recent Federal Regulation Documents

Information Collection Activity Under OMB Review
Document Number: 05-12727
Type: Notice
Date: 2005-06-28
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below has been forwarded to the Office of Management and Budget (OMB) for review and comments. The ICR describes the nature of the information collection and its expected burden. The Federal Register Notice with a 60-day comment period soliciting comments on the following information collection was published on April 14, 2005 [70 FR 19837].
Hazardous Materials: Requirements for Cylinders; Extension of Comment Period
Document Number: 05-12459
Type: Proposed Rule
Date: 2005-06-23
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
PHMSA is extending until September 6, 2005, the period for interested persons to submit comments on the March 9, 2005 notice of proposed rulemaking. In the March 9, 2005 NPRM, we proposed to amend the Hazardous Materials Regulations to adopt standards for the design, construction, maintenance and use of cylinders and multiple-element gas containers (MEGCs) based on the standards contained in the United Nations (UN) Recommendations on the Transport of Dangerous Goods. Aligning the HMR with the UN Recommendations will promote flexibility, permit the use of technological advances for the manufacture of pressure receptacles, provide for a broader selection of pressure receptacles, reduce the need for exemptions, and facilitate international commerce in the transportation of compressed gases.
Pipeline Safety: Use of Polyamide-11 Plastic Pipe in Gas Pipelines
Document Number: 05-12356
Type: Proposed Rule
Date: 2005-06-22
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
The Office of Pipeline Safety (OPS) seeks public comments on two petitions for rulemaking filed by Arkema, Inc. The petitions request changes to the gas pipeline safety regulations to increase the design factor for new polyamide11 (PA-11) pipe and to allow use of PA-11 pipe for systems operating at up to 200 pounds per square inch gauge pressure (psig). These requested changes will allow the use of PA-11 pipe in gas pipelines in place of metal pipe.
Office of Hazardous Materials Safety; Notice of Application for Exemptions
Document Number: 05-12132
Type: Notice
Date: 2005-06-21
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the procedures governing the application for, and the processing of, exemptions from the Department of Transportation's Hazardous Material Regulations (49 CFR Part 107, Subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular exemption is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Office of Hazardous Materials Safety; Notice of Applications for Modification of Exemption
Document Number: 05-12131
Type: Notice
Date: 2005-06-21
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the procedures governing the application for, and the processing of, exemptions from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of application have been shown in earlier Federal Register publications, they are not repeated here. Request of modifications of exemptions (e.g. to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. There applications have been separated from the new application for exemption to facilitate processing.
Pipeline Safety: Public Meeting on Applying, Interpreting, and Evaluating Data From In-Line Inspection Devices
Document Number: 05-11866
Type: Notice
Date: 2005-06-16
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
The Pipeline and Hazardous Materials Safety Administration's Office of Pipeline Safety (OPS) is hosting a public meeting to discuss concerns it has with how operators are applying, interpreting, and evaluating data acquired from In-Line Inspection Devices (ILI), and OPS's expectations about how operators should be effectively integrating this data with other information about the operator's pipeline. The meeting will be held Thursday, August 11, 2005, in Houston, TX, and is open to all interested parties.
Pipeline Safety: Pipeline Operator Public Awareness Program
Document Number: 05-11865
Type: Rule
Date: 2005-06-16
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
PHMSA is correcting a Final Rule published in the Federal Register on May 19, 2005 (70 FR 28833). That Final Rule amended requirements for pipeline operators in 49 CFR parts 192 and 195 to develop and implement public awareness programs and incorporated by reference the guidelines of the American Petroleum Institute (API) Recommended Practice (RP) 1162. The document was assigned the amendment numbers 192-100 and 195-84, which were already assigned to different amendments. This document corrects the amendment numbers, and corrects the language amending part 192 so that it is consistent with part 195.
Pipeline Safety: Response Plans for Onshore Transportation-Related Oil Pipelines
Document Number: 05-11444
Type: Rule
Date: 2005-06-16
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
On February 23, 2005, the U.S. Department of Transportation, Pipeline and Hazardous Materials Safety Administration, Office of Pipeline Safety (OPS) issued a final rule adopting as a final rule, the interim final rule which was issued on January 5, 1993. This final rule also made minor amendments to some of the regulations in Part 194 in response to public comments and the experience that OPS gained in implementing the interim final rule, leading spill response exercises, and responding to actual spills. The amendments were generally technical in nature and did not involve additional costs to pipeline operators or the public. In issuing the final rule, a table was inadvertently misprinted. This table in Sec. 194.105(b)(3) specifies the potential spill volume reduction credits operators may use when they have secondary containment and other spill prevention measures on breakout tanks. These spill reduction credits are used when calculating the worst case discharge volume. This correction replaces the incorrect table with the correct table.
Pipeline Safety: Operator Qualifications; Statutory Changes
Document Number: 05-11864
Type: Rule
Date: 2005-06-15
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
This document confirms the effective date of the direct final rule published in the Federal Register on March 3, 2005. The direct final rule amended regulations that require operators of gas and hazardous liquid pipelines to conduct programs to evaluate the qualifications of individuals who perform certain safety-related tasks on pipelines.
Hazardous Materials; Transportation of Lithium Batteries
Document Number: 05-11765
Type: Proposed Rule
Date: 2005-06-15
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
The Pipeline and Hazardous Materials Safety Administration (PHMSA) is publishing this initial regulatory flexibility analysis to aid the public in commenting upon the potential small business impacts of the proposals in our April 2, 2002 notice of proposed rulemaking to amend the requirements in the Hazardous Materials Regulations (HMR) on: (1) Exceptions for ``small'' and for ``mid-size'' batteries (i.e., cells up to 5 grams of lithium content and batteries up to 25 grams of lithium content); and (2) exceptions for aircraft passengers and crew. These changes are being proposed in order to clarify requirements to promote safer transportation practices; promote compliance and enforcement; eliminate unnecessary regulatory requirements; facilitate international commerce; and make these requirements easier to understand. We will consider comments received to improve our regulatory flexibility analysis and in making our decision on a final rule.
Harmonization With the United Nations Recommendations, International Maritime Dangerous Goods Code, and International Civil Aviation Organization's Technical Instructions; Correction; Final Rule
Document Number: 05-11648
Type: Rule
Date: 2005-06-14
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
On December 20, 2004, the Research and Special Programs Administration (RSPA)the predecessor agency to the Pipeline and Hazardous Materials Safety Administration (PHMSA)published a final rule under Docket Number RSPA-04-17036 (HM-215G) amending the Hazardous Materials Regulations (HMR) to maintain alignment with international standards by incorporating various amendments, including changes to proper shipping names, hazard classes, packing groups, special provisions, packaging authorizations, air transport quantity limitations and vessel stowage requirements. Because of recent changes to the International Maritime Dangerous Goods Code (IMDG Code), the International Civil Aviation Organization's Technical Instructions for the Safe Transport of Dangerous Goods by Air (ICAO Technical Instructions), and the United Nations Recommendations on the Transport of Dangerous Goods (UN Recommendations), these revisions are necessary to facilitate the transport of hazardous materials in international commerce. This final rule corrects errors in the December 20, 2004 final rule.
Hazardous Materials; Miscellaneous Amendments
Document Number: 05-11647
Type: Rule
Date: 2005-06-13
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
This final rule amends the Hazardous Materials Regulations by incorporating miscellaneous changes based on petitions for rulemaking and PHMSA initiatives. The intended effect of these regulatory changes is to update, clarify or provide relief from certain regulatory requirements.
Hazardous Materials: Incorporation of Exemptions Into Regulations; Notice of Information Collection Approval
Document Number: 05-11399
Type: Rule
Date: 2005-06-08
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
This final rule notice announces Office of Management and Budget (OMB) approval of information collection request (ICR) OMB No. 2137-0620, ``Inspection and Testing of Meter Provers.'' This information collection has been approved by OMB until May 31, 2008. This notice also makes appropriate revisions to regulations concerning the Paperwork Reduction Act to incorporate this new information collection approval under OMB Control No. 2137-0620.
Office of Hazardous Materials Safety; Notice of Delays in Processing of Exemption Applications
Document Number: 05-11010
Type: Notice
Date: 2005-06-03
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
In accordance with the requirements of 49 U.S.C. 5117(c), PHMSA is publishing the following list of exemption applications that have been in process for 180 days or more. The reason(s) for delay and the expected completion date for action on each application is provided in association with each identified application.