Historic Preservation, Advisory Council September 2015 – Federal Register Recent Federal Regulation Documents

This interim Final Rule amends NHTSA's regulation on the importation of motor vehicles and motor vehicle equipment subject to Federal safety, bumper and theft prevention standards by allowing importers to provide information to United States Customs and Border Protection (CBP) in either electronic or paper format. Presently, certain regulatory provisions require importers to provide documentation or information in a ``written statement'' or in ways that imply the submission of a paper document, including the phrases ``in duplicate,'' ``a copy of,'' a ``document,'' and ``accompanied by a statement.'' Over the course of the coming months, CBP plans to allow importers to file importation information in paper format only or electronic format only. To allow importers to choose their preferred format for filing information required by NHTSA, the agency is amending its importation regulations to specify that importers have the option to file all required information electronically, in addition to the paper option currently available. This document is being issued as an interim Final Rule to provide timely assistance to importers by allowing alternative methods of filing with CBP the importation information required by NHTSA. The amendments in this interim Final Rule do not create any new rights or obligations, nor impose any new reporting requirements. The agency herein requests comments on the rule. The agency will publish a notice responding to any comments received, if any, and will amend provisions of the regulation if appropriate.

We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 airplanes. This AD was prompted by numerous reports of failures of the proximity sensor within the slat skew detection mechanism assembly (DMA) leading to slats up landing events. This AD requires replacing the slat skew DMAs with new slat skew DMAs, and marking the existing identification plates on the slat with the new part number. We are issuing this AD to prevent failure of the proximity sensor, which could result in the slats being shut down and a slats up high speed landing. This condition, in combination with abnormal landing conditions such as a short runway or adverse weather conditions, could result in a runway excursion.

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400 series airplanes. This AD was prompted by reports of chafing of the fuel lines due to contact with the surrounding structures in the fuel tank. This AD requires replacing and modifying fuel lines, revising the maintenance or inspection program, as applicable, to include critical design configuration control limitations (CDCCL) and airworthiness limitation (AWL) items, and, for certain airplanes, removing certain clamps and mounting hardware. We are issuing this AD to prevent chafing of the fuel lines in the fuel tank, which could result in potential ignition sources in the fuel tank in the event of a lightning strike and consequent fire or explosion.

We are adopting a new airworthiness directive (AD) for Vulcanair S.p.A. Model P.68R airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as a discrepancy in the climb performance reported in the airplane flight manual and in the actual performance of the airplane. We are issuing this AD to require actions to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400, -401, and -402 airplanes. This AD was prompted by a report of a main landing gear (MLG) parking brake becoming dislodged from its mounting bracket due to an improperly installed quick release pin of the hand pump lever. This AD requires removing the hand pump lever of the parking brake from the right-hand side nacelle. We are issuing this AD to prevent an unsecured lever from migrating from its stowed position, fouling against the MLG, and subsequently puncturing the nacelle structure, which could adversely affect the safe landing of the airplane.

Notice is hereby given of a meeting of the National Grain Car Council (NGCC), pursuant to the Federal Advisory Committee Act, 5 U.S.C., app. 2 Sec. 10(a)(2).

NHTSA has forwarded the information collection request described in this notice to the Office of Management and Budget (OMB) for approval of a new information collection. We published a Federal Register Notice with a 60-day public comment period on this information collection on April 29, 2015. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995.

The FAA is issuing this notice to advise the public of a meeting of the ARAC.

FRA hereby gives notice that it is submitting the following Information Collection request (ICR) to the Office of Management and Budget (OMB) for Emergency Processing under the Paperwork Reduction Act of 1995. FRA requests that OMB authorize the collection of information identified below seven days after publication of this Notice for a period of 180 days.