Federal Aviation Administration October 13, 2021 – Federal Register Recent Federal Regulation Documents

Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
Document Number: 2021-22210
Type: Rule
Date: 2021-10-13
Agency: Federal Aviation Administration, Department of Transportation
This rule amends, suspends, or removes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide for the safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Standard Instrument Approach Procedures, and Takeoff Minimums and Obstacle Departure Procedures; Miscellaneous Amendments
Document Number: 2021-22209
Type: Rule
Date: 2021-10-13
Agency: Federal Aviation Administration, Department of Transportation
This rule establishes, amends, suspends, or removes Standard Instrument Approach Procedures (SIAPS) and associated Takeoff Minimums and Obstacle Departure procedures (ODPs) for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.
Airworthiness Directives; The Boeing Company Airplanes
Document Number: 2021-22203
Type: Proposed Rule
Date: 2021-10-13
Agency: Federal Aviation Administration, Department of Transportation
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 737-700, -800, and -900ER series airplanes. This proposed AD was prompted by reports of incorrectly installed fuselage skin fasteners. This proposed AD would require a detailed inspection of a certain body station bulkhead, between certain stringers, for any incorrectly installed fastener common to fuselage skin, and applicable on-condition actions. The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Canada Limited Partnership (Type Certificate Previously Held by C Series Aircraft Limited Partnership (CSALP); Bombardier, Inc.) Airplanes
Document Number: 2021-22199
Type: Rule
Date: 2021-10-13
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for certain Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500- 1A11 airplanes. This AD was prompted by a report that following an in- service engine shutdown during taxi, water was found to be dripping into the forward avionics bay; the water caused a short circuit and tripped a circuit breaker. This AD requires replacing the forward galley slotted drain covers with solid blanking plates and modifying the associated drain tubing to block water. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
Document Number: 2021-22198
Type: Rule
Date: 2021-10-13
Agency: Federal Aviation Administration, Department of Transportation
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by a report that during flight tests, the opening of the ram air outlet flaps was found to cause a disturbance of the air flow around the ram air turbine (RAT) when the landing gear (L/G) is extended. This AD requires revising the existing airplane flight manual (AFM) and applicable corresponding operational procedures to provide procedures for all engines failure and L/G gravity extension related to certain software, and installing Airbus temporary quick change (ATQC) V3 for the flight warning system (FWS) software (SW) standard (STD) 6/ 2.0, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Proposed Modification of Class D and Class E Airspace; China Lake NAWS (Armitage Field) Airport, CA
Document Number: 2021-22195
Type: Proposed Rule
Date: 2021-10-13
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to modify the Class D airspace at China Lake NAWS (Armitage Field) Airport, China Lake, CA. This action also proposes to modify the Class E airspace extending upward from 700 feet above the surface. Additionally, this action proposes to remove the China Lake (Navy) TACAN from the Class E5 text header and airspace description. Lastly, this action proposes numerous administrative updates to the Class D and Class E5 text headers and the Class D airspace description. This action would ensure the safety and management of instrument flight rules (IFR) operations at the airport.
Proposed Modification of Class E Airspace; Inyokern Airport, CA
Document Number: 2021-22193
Type: Proposed Rule
Date: 2021-10-13
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to modify the Class E airspace at Inyokern Airport, Inyokern, CA. This action also proposes two administrative updates to the Class E5 text header. This action would ensure the safety and management of instrument flight rules (IFR) operations at the airport.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.