Federal Aviation Administration 2013 – Federal Register Recent Federal Regulation Documents

The FAA is correcting an airworthiness directive (AD) that was published in the Federal Register. The AD applies to certain Eurocopter France (Eurocopter) Model AS350B3 helicopters. The reference to Title 14, Code of Federal Regulations (14 CFR) 91.173 in the Required Actions section is incorrect. This document corrects that error. In all other respects, the original document remains the same.

We are adopting a new airworthiness directive (AD) for all Pratt & Whitney Division (PW) turbofan engine model PW4074, PW4074D, PW4077, PW4077D, PW4084D, PW4090, and PW4090-3 with a certain second- stage high-pressure turbine (HPT) air seal part number installed. This AD was prompted by discovery of cracks in second-stage HPT air seals. This AD requires inspection and removal from service of HPT air seals that fail inspection. We are issuing this AD to prevent failure of the second-stage HPT air seal, which could lead to an uncontained engine failure and damage to the airplane.

We propose to supersede airworthiness directive (AD) 2007-16- 19, which applies to certain The Boeing Company Model 747-200B, 747- 300, and 747-400 series airplanes. AD 2007-16-19 requires repetitive detailed inspections for cracking of the aft tension tie channels from body station (BS) 1120 to BS 1220 and from BS 880 to BS 1100, and corrective actions if necessary, and optional terminating action. Since we issued that AD, analysis has indicated the need to mandate the previously optional modification. This proposed AD would retain the existing requirements, limit the area of the detailed inspection, add repetitive surface high-frequency eddy current inspections, and mandate the previously optional terminating action. We are proposing this AD to prevent fatigue cracking of the tension ties, which could result in reduced structural integrity of the airplane and rapid depressurization of the airplane.

We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 767-200, -300, -300F, and -400ER airplanes. This proposed AD was prompted by reports indicating that a standard access door was located where an impact-resistant access door was required, and stencils were missing from some impact-resistant access doors. This proposed AD would require an inspection of the left- and right-hand wing fuel tank access doors to determine that impact- resistant access doors are installed in the correct locations, and to replace any door with an impact-resistant access door if necessary. This proposed AD also would require an inspection for stencils and index markers on impact-resistant access doors, and application of new stencils or index markers if necessary. This proposed AD would also require revising the maintenance program to incorporate changes to the airworthiness limitations section. We are proposing this AD to prevent foreign object penetration of the fuel tank, which could cause a fuel leak near an ignition source (e.g., hot brakes or engine exhaust nozzle), consequently leading to a fuel-fed fire.

This action proposes to amend Class E airspace at Kankakee, IL. Additional controlled airspace is necessary to accommodate amended Standard Instrument Approach Procedures (SIAP) at Greater Kankakee Airport. The FAA is taking this action to enhance the safety and management of Instrument Flight Rules (IFR) operations for SIAPs at the airport. Geographic coordinates would also be updated.

The FAA proposes to rule and invites public comment on the release of land, Lot 14, at the Ottumwa Regional Airport, Ottumwa, Iowa, under the provisions of 49 U.S.C. 47107(h)(2).

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval for a new information collection. This notice corrects a notice published in the Federal Register on July 31, 2013 (78 FR 46405) to include additional background information, to include the docket number FAA-2013-0684, which contains supplementary documentation on the subject information collection, and to extend the comment period. The FAA Modernization and Reform Act of 2012 included a mandate to begin collection of operational data from Air Ambulance operators. FAA is to summarize the data and report to Congress no later than February 14, 2014, and annually thereafter.

This action proposes to amend Class E airspace at Hampton, IA. Decommissioning of the Hampton non-directional beacon (NDB) at Hampton Municipal Airport has made reconfiguration necessary for standard instrument approach procedures and for the safety and management of Instrument Flight Rules (IFR) operations at the airport.

We propose to adopt a new airworthiness directive (AD) for certain Turbomeca S.A. Arriel 1A1, 1A2, 1B, 1C, 1C1, 1C2, 1D, 1D1, 1E2, 1K1, 1S, and 1S1 turboshaft engines. This proposed AD was prompted by a ``chip illumination event'' in flight on a Turbomeca S.A. Arriel 1 engine. This proposed AD would require a one-time inspection of the free turbine (FT) module (M04) for the affected Turbomeca S.A. Arriel 1 engines and, if a discrepancy is found, repair of the affected module. We are proposing this AD to prevent a loss of FT bearing lubrication, resulting FT module failure, damage to the engine, and damage to the aircraft.

This rule establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

We are superseding an existing airworthiness directive (AD) for all BRP-Powertrain GmbH & Co KG Rotax model 912 F2; 912 F3; 912 F4; 912 S2; 912 S3; 912 S4; 914 F2; 914 F3; and 914 F4 reciprocating engines. That AD required a one-time visual inspection for excessive oil or carbon deposits on the cylinder No. 2 and No. 3 (\2/3\) spark plug center and grounding electrodes, and if found, replacement of the cylinder head before further flight. This AD was prompted by a report that additional engine cylinder heads are likely to be affected. We are issuing this AD to prevent excessive oil consumption, which could result in an in-flight engine shutdown, forced landing, and damage to the airplane.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on May 20, 2013, vol. 78, no. 97, pages 29425-29426. The FAA uses the information collected related to public safety to ensure that a launch or reentry operation involving a human on board a vehicle will meet the risk criteria and requirements with regard to ensuring public safety.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on May 20, 2013, vol. 78, no. 97, page 29426. The information collected is needed for applicants' noise certification compliance reports in order to demonstrate compliance with 14 CFR Part 36.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on May 20, 2013, vol. 78, no. 97, pages 29425-29426. This program requires public agencies and certain members of the aviation industry to prepare and submit applications and reports to the FAA. Through this program the FAA provides additional funding for airport development which is needed now and in the future.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on May 20, 2013, vol. 78, no. 97, pages 29426-29427. The collection of information is for the purpose of obtaining essential information concerning the applicant's professional and personal qualifications. The FAA uses the information provided to screen and select designees who act as representatives of the FAA Administrator in performing various certification and examination functions under Title VI of Federal Aviation Act.

We propose to supersede an existing airworthiness directive (AD) that applies to certain Rolls-Royce Corporation (RRC) AE 3007A series turbofan engines. The existing AD currently requires removing certain high-pressure turbine (HPT) stage 2 wheels, or performing inspections on them, and reduces their approved life limits. This proposed AD would clarify the AE 3007A turbofan engine model applicability, would further reduce the approved life limits of affected HPT stage 2 wheels, and would eliminate the inspections required by the existing AD. We are proposing this AD to prevent uncontained failure of the HPT stage 2 wheel, damage to the engine, and damage to the airplane.

This action amends Class E Airspace at Bedford, PA, as the St. Thomas VORTAC has been decommissioned and new standard instrument approach procedures developed for Instrument Flight Rules (IFR) operations at Bedford County Airport. This enhances the safety and management of aircraft operations at the airport. This action also updates the geographic coordinates of the airport.

This action corrects a final rule published in the Federal Register May 29, 2013 that establishes Class E en route airspace at the Tuba City VHF Omni-Directional Radio Range Tactical Air Navigational Aid (VORTAC), Tuba City, AZ. In that rule, an error was made in the legal description for Tuba City, identifying the region as ANM instead of AWP.

This action amends Class D and Class E airspace at San Marcos, TX. Additional controlled airspace is necessary to accommodate new Area Navigation (RNAV) Standard Instrument Approach Procedures at San Marcos Municipal Airport and the decommissioning of the Garys Locator Outer Marker (LOM). This action enhances the safety and management of Instrument Flight Rule (IFR) operations at the airport. Geographic coordinates are also updated.

This action amends Class D airspace at Waco, TX, by separating the Class D airspace at Waco Regional Airport from the Class D airspace at TSTC-Waco Airport. The FAA is taking this action to alleviate multiple air traffic controllers handling the same airspace and for the safety and management of Instrument Flight Rule (IFR) operations at the airport. The geographic coordinates for Waco Regional Airport are also adjusted.

This action establishes Class E airspace at Wagner, SD. Controlled airspace is necessary to accommodate new Area Navigation (RNAV) Standard Instrument Approach Procedures at Wagner Municipal Airport. The FAA is taking this action to enhance the safety and management of Instrument Flight Rule (IFR) operations at the airport.

This action amends Class E airspace at Mason, TX. Additional controlled airspace is necessary to accommodate new Area Navigation (RNAV) Standard Instrument Approach Procedures at Mason County Airport. This action enhances the safety and management of Instrument Flight Rule (IFR) operations at the airport.

This action amends Class E airspace at Gruver, TX. Additional controlled airspace is necessary to accommodate new Area Navigation (RNAV) Standard Instrument Approach Procedures at Gruver Municipal Airport. This action enhances the safety and management of Instrument Flight Rule (IFR) operations at the airport.

This action establishes Class E airspace at Mahnomen, MN. Controlled airspace is necessary to accommodate new Area Navigation (RNAV) Standard Instrument Approach Procedures at Mahnomen County Airport. The FAA is taking this action to enhance the safety and management of Instrument Flight Rule (IFR) operations at the airport.

This action proposes to establish Class E Airspace at McConnellsburg, PA, to accommodate a new Area Navigation (RNAV) Global Positioning System (GPS) special Standard Instrument Approach Procedure (SIAP) serving Fulton County Medical Center Heliport. This action would enhance the safety and airspace management of Instrument Flight Rules (IFR) operations within the National Airspace System.