Federal Aviation Administration May 2008 – Federal Register Recent Federal Regulation Documents

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.

We are superseding an existing airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are revising an earlier NPRM for the products listed above. This action revises the earlier NPRM by expanding the scope. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to adopt a new airworthiness directive (AD) for certain Hawker Beechcraft Corporation (HBC) Model 390 airplanes. This proposed AD would require you to remove the current preformed packing, elbow fitting, and jam nut from the left and right hydraulic pump pressure output port and replace with new parts. This proposed AD would also require you to install a hydraulic pump case drain check valve. This proposed AD results from nine occurrences of hydraulic fluid leaking from the engine hydraulic pump output fitting as a result of an improperly installed elbow connecting the output port to the pulse dampener hose. We are proposing this AD to prevent hydraulic fluid leaks from the left and right hydraulic fluid pump and to prevent the flow of hydraulic fluid into the engine compartment. The loss of hydraulic fluid can result in loss of airplane hydraulic system pressure and the consequent loss of hydraulic system functions including gear extension/retraction, spoiler functions, and anti-skid braking system actuation. The inability of the hydraulic installation to isolate flow of hydraulic fluid could result in a hazardous amount of flammable fluid in the corresponding engine compartment. These conditions, if not corrected, could result in loss of system functions and/or fire in the engine compartment.

The Federal Aviation Administration (FAA) announces that it is reviewing a proposed noise compatibility program that was submitted for Fresno Yosemite International Airport (FAT) under the provisions of 49 U.S.C. 47504 et seq. (the Aviation Safety and Noise Abatement Act, hereinafter referred to as ``the Act'') and 14 CFR part 150 by City of Fresno, California. This program was submitted subsequent to a determination by FAA that associated noise exposure maps submitted under 14 CFR part 150 for FAT were in compliance with applicable requirements, effective July 6, 2005 (70 FR 50437-50438). The proposed noise compatibility program will be approved or disapproved on or before October 15, 2008.