Federal Aviation Administration May 16, 2023 – Federal Register Recent Federal Regulation Documents

The FAA is superseding Airworthiness Directive (AD) 2018-05-06 and AD 2021-08-19, which both applied to certain The Boeing Company Model 787-8, -9, and -10 airplanes. AD 2018-05-06 required repetitive inspections of the bilge barriers located in the forward and aft cargo compartments for disengaged decompression panels, and reinstalling any disengaged panels; and required replacing the existing decompression panels with new panels and straps, which terminated the repetitive inspections. AD 2021-08-19 required repetitive general visual inspections for disengaged or damaged decompression panels of the bilge barriers located in the forward and aft cargo compartments, reinstallation of disengaged but undamaged panels, and replacement of damaged panels. This AD was prompted by reports of multiple incidents of torn decompression panels found in the bilge area, and the development of new procedures for changing or replacing the bilge barrier assembly in the forward and aft cargo compartments. This AD retains the requirements of AD 2021-08-19 and requires changing or replacing the bilge barrier assembly in the forward and aft cargo compartments, which terminates the repetitive inspections. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain Gulfstream Aerospace Corporation Model G-1159A and G-1159B airplanes and all Model G-IV and GIV-X airplanes. This AD was prompted by a report that the ground spoiler actuator installation does not preclude improper hydraulic line connections that could result in unintended asymmetrical spoiler deployment. This AD requires incorporating corrective actions that physically prevent improper connection of the hydraulic lines to the ground spoiler actuator. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain De Havilland Aircraft of Canada Limited Model DHC-8-401 and - 402 airplanes. This AD was prompted by reports of corrosion on the horizontal stabilizer lower center skin panel, including a finding of corrosion where the skin thickness had been substantially reduced, which affected design margins. This AD requires inspecting the horizontal stabilizer lower center skin panel for corrosion, and reworking, repairing, or replacing the lower center skin panel if necessary. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by reports of broken lower attachment studs on the AFT galley complex. This AD requires repetitive detailed inspections of the lower attachment studs and, depending on findings, replacement of the lower attachment studs, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2019-18- 09, which applied to all Lockheed Martin Corporation/Lockheed Martin Aeronautics Company Model 382, 382B, 382E, 382F, and 382G airplanes; and Model C-130A, HP-C-130A, EC-130Q, C-130B, and C-130H airplanes. AD 2019-18-09 required a visual inspection of the center wing upper and lower rainbow fittings for cracks, an eddy current inspection of the center wing lower rainbow fittings for cracks, and replacement if necessary. This AD was prompted by an analysis of reported cracks showing repetitive inspections are needed to adequately address cracked inner tangs of the center wing lower rainbow fittings. This AD requires repetitive inspections of the center wing upper and lower rainbow fittings for cracks and replacement if necessary. The FAA is issuing this AD to address the unsafe condition on these products.