Federal Aviation Administration March 12, 2021 – Federal Register Recent Federal Regulation Documents

The FAA is reopening the comment period for an earlier proposed rulemaking (NPRM) for certain Bell Textron Canada Limited (type certificate previously held by Bell Helicopter Textron Canada Limited) Model 206L series helicopters. The NPRM proposed to require replacing certain low fuel level detector switch units (switch units) and testing certain other switch units to determine if replacement is required. The NPRM was prompted by a manufacturing flaw that could cause the switch units to hang in the high position and fail to indicate a low fuel condition. This action reopens the comment period because a significant amount of time has elapsed since the NPRM was published. This action also revises the NPRM by updating the type certificate holder's name, updating the estimated cost information, clarifying and expanding the applicability, clarifying the requirements, adding a compliance time, and adding parts installation prohibitions. The FAA is proposing this airworthiness directive (AD) to address the unsafe condition on these products. Since these actions would impose an additional burden over those in the NPRM, the agency is requesting comments on this SNPRM.

The FAA is adopting a new airworthiness directive (AD) for certain serial-numbered Leonardo S.p.a. (Leonardo) Model A109S and AW109SP helicopters. This AD requires installing a placard in the baggage compartment, revising the existing Rotorcraft Flight Manual (RFM) for your helicopter, and inspecting the installation of the terminal lugs. Depending on the outcome of the inspection, this AD requires restoring the installation of the terminal lugs. This AD would also require modifying the helicopter to shim the baggage fairing assy (fwd up) away from the circuit breaker panel and incorporating protective coverings. This AD was prompted by reports of several occurrences of fire ignition and smoke in the baggage compartment. The actions of this AD are intended to address an unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2018-15- 02, which applied to certain Airbus Helicopters Model AS350B, AS350B1, AS350B2, AS350B3, AS350BA, AS355E, AS355F, AS355F1, AS355F2, AS355N, and AS355NP helicopters. AD 2018-15-02 required repetitively inspecting the tail rotor (TR) pitch rod for a damaged elastomeric ball joint, and corrective action if necessary. This AD continues to require the repetitive inspections and allows the repetitive inspection interval to be extended under certain conditions, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD was prompted by a report of several cases of damaged TR pitch rod ball joints. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is superseding Airworthiness Directive (AD) 2016-23- 05, which applied to certain Airbus Helicopters Model SA-365N1, AS- 365N2, AS 365 N3, SA-366G1, EC 155B, and EC155B1 helicopters. AD 2016- 23-05 required repetitive checks of the oil level of the tail rotor gearbox and, if necessary, filling the oil to the maximum level; and replacement of a certain control rod double bearing (bearing) with a new bearing. This AD retains the requirements of AD 2016-23-05 and also requires modifying the helicopter by replacing the tail gearbox (TGB) control shaft guide bushes; repetitive inspections of the TGB magnetic plug and corrective actions if necessary; repetitive replacements of the bearing; and modifying the helicopter by replacing the TGB; as specified in a European Aviation Safety Agency (now European Union Aviation Safety Agency) (EASA) AD, which is incorporated by reference. This AD also adds helicopters to the applicability. This AD was prompted by reports of occurrences of loss of yaw control due to failure of the TGB bearing. The FAA is issuing this AD to address the unsafe condition on these products.

This action removes the Class E airspace extending upward from 700 feet above the surface at Orange City Municipal Airport, Orange City, IA and amends the Class E airspace extending upward from 700 feet above the surface at the Le Mars Municipal Airport, Le Mars, IA. This action is the result of an airspace review caused by the decommissioning of Orange City (ORC) non-directional beacon (NDB), and the Automated Weather Observing System (AWOS) navigation aids, and the closure of the Orange City Municipal Airport. Additionally, the geographical coordinates for the Le Mars Municipal Airport, Le Mars, IA, have been updated to coincide with the FAA's aeronautical database.

This notice contains a summary of a petition by Rolls-Royce Deutschland LTD & Co KG seeking relief from specific regulatory requirements. The purpose of this notice is to improve the public's awareness of, and participation in, the FAA's exemption process. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.