Federal Aviation Administration November 6, 2019 – Federal Register Recent Federal Regulation Documents
Results 1 - 5 of 5
Airworthiness Directives; Bombardier, Inc., Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Bombardier, Inc., Model BD-100-1A10 airplanes. This proposed AD was prompted by a report that during ALTS CAP or (V) ALTS CAP mode, the flight guidance/autopilot does not account for engine failure while capturing an altitude. This proposed AD would require revising the existing airplane flight manual (AFM) to provide the flightcrew with new warnings for ``Autoflight'' and ``Engine Failure in Climb During ALTS CAP.'' The FAA is proposing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 airplanes. This AD was prompted by a report of cracked external lugs of the aluminum cargo door latch fittings in the lower part of the forward and aft cargo doors. This AD requires repetitive detailed inspections of the external lugs of the aluminum cargo door latch fittings for cracks, and corrective actions if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. Accomplishing the installation of new aluminum cargo door latch fittings constitutes terminating action for the repetitive detailed inspections. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Saab AB, Saab Aeronautics (Formerly Known as Saab AB, Saab Aerosystems) Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Saab AB, Saab Aeronautics Model SAAB 2000 airplanes. This AD was prompted by reports of loose and irregular fasteners at the forward end of the nacelle upper longeron, where the bulkhead frame and struts are attached to the engine mounting structure (EMS). This AD requires modification of the EMS and structural attachments. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Airbus SAS Model A330-200, A330-200 Freighter, A330-300, A340- 200, A340-300, A340-500, and A340-600 series airplanes. This AD was prompted by reports that non-approved passenger oxygen containers (POCs) may have been installed on the affected airplanes. This AD requires a one-time special detailed inspection (SDI) of each POC, and replacement if necessary, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus SAS Airplanes
The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A320-251N and -271N airplanes, and Model A321-251N, - 253N, -271N, and -272N airplanes. This AD was prompted by reports that the regulated bleed temperature was measured above the design target with a temperature regulation shift phenomenon, and investigation results show that incorrect temperature regulation can degrade pneumatic system components located downstream of the pre-cooler. This AD requires uploading improved bleed monitoring computer (BMC) software (SW), as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
