Federal Aviation Administration December 1, 2017 – Federal Register Recent Federal Regulation Documents
Results 1 - 3 of 3
Petition for Exemption; Summary of Petition Received
This notice contains a summary of a petition seeking relief from specified requirements of Federal Aviation Regulations. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of the FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.
Airworthiness Directives; Airbus Airplanes
We are superseding Airworthiness Directive (AD) 2016-20-11, which applied to certain Airbus Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model A300 C4-605R Variant F airplanes (collectively called Model A300-600 series airplanes); and Airbus Model A310 series airplanes. AD 2016-20-11 required repetitive inspections of the external area of the aft cargo door sill beam for cracking, repetitive inspections for fatigue cracking of the cargo door sill beam, lock fitting, and torsion box plate, and repair if necessary. This new AD retains the inspections for cracking, and repair if necessary; and requires reinforcement of the aft cargo door sill beam area. This AD was prompted by the development of a reinforcement modification of the aft cargo door sill beam area, which constitutes terminating action for the repetitive inspections. We are issuing this AD to address the unsafe condition on these products.
Airworthiness Directives; Airbus Airplanes
We are superseding Airworthiness Directive (AD) 2014-08-01, which applied to all Airbus Model A318, A319, A320, and A321 series airplanes. AD 2014-08-01 required an inspection for part numbers of the interconnecting struts and, for affected interconnecting struts, identification of the part and serial numbers of the associated target and proximity sensors and replacement or re-identification of the flap interconnecting strut if necessary. This AD continues to require an inspection to verify the interconnecting strut part number. This AD also provides a new compliance time and an additional inspection for previously inspected airplanes. This AD was prompted by an investigation that showed that when a certain combination of target/ proximity sensor serial numbers is installed on a flap interconnecting strut, a ``target FAR'' signal cannot be detected when reaching the mechanical end stop of the interconnecting strut. We are issuing this AD to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
