Federal Aviation Administration August 1, 2017 – Federal Register Recent Federal Regulation Documents

These special conditions are issued for the Boeing Model 747-8 airplane. This airplane, as modified by LifePort Inc. (LifePort), will have novel or unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport- category airplanes. These design features are single- and multiple- occupant side-facing seats (i.e., seats positioned in the airplane with the occupant facing 90 degrees to the direction of airplane travel). The applicable airworthiness regulations do not contain adequate or appropriate safety standards for these design features. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

This action proposes to establish Class E airspace extending upward from 700 feet above the surface at Gregory M. Simmons Memorial Airport, Cisco, TX, to accommodate a new public instrument approach procedure at the airport and for safety and management of instrument flight rules (IFR) operations at the airport.

We are adopting a new airworthiness directive (AD) for certain Airbus Model A300 B4-600R series airplanes, Model A300 C4-605R Variant F airplanes, and Model A300 F4-600R series airplanes. This AD was prompted by the results of a full stress analysis of the lower area of a certain frame that revealed that a crack could occur in this area after a certain number of flight cycles. This AD requires an inspection of the lower area of a certain frame radius for cracking, and corrective action if necessary. We are issuing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Diamond Aircraft Industries GmbH Model DA 42 airplanes. This AD requires installing engine exhaust pipe clamps with spring washers, repetitively inspecting the engine exhaust pipe clamps for cracks, and replacing the clamps if found cracked. This AD was prompted by cracks in the affected engine exhaust pipes, which could cause failure of the propeller regulating valve because of hot exhaust gases coming from the fractured pipes. We are issuing this AD to correct the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 787-9 airplanes. This AD was prompted by a determination that the shoulder bolt used on the outboard clevis of the forward support fitting of the ram air turbine (RAT) might not be long enough to allow for proper installation of the RAT; therefore, the clevis of the joint could be clamped together, resulting in reduced fatigue life and possible fracture of the clevis. This AD requires inspecting for cracking of the clevis of the forward support fitting of the RAT, installing a longer shoulder bolt, and replacing the forward support fitting if any cracking is found. We are issuing this AD to address the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc., Model DHC-8-102, -103, -106, -201, -202, -301, -311, and -315 airplanes. This AD was prompted by reports of undamped main landing gear (MLG) extension in-service. This AD requires replacement of the MLG retraction actuator rod-ends on both MLG assemblies. We are issuing this AD to address the unsafe condition on these products.