Federal Aviation Administration November 2014 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 airplanes. This proposed AD was prompted by numerous reports of failures of the proximity sensor within the slat skew detection mechanism assembly (DMA) leading to slats up landing events. This proposed AD would require replacing the slat skew DMAs with new slat skew DMAs, and marking the existing identification plates on the slat with the new part number. We are proposing this AD to prevent failure of the proximity sensor, which could result in the slats being shut down and a slats up high speed landing. This condition, in combination with abnormal landing conditions such as a short runway or adverse weather conditions, could result in a runway excursion.

We are superseding Airworthiness Directive (AD) 2014-07-51 for AgustaWestland S.p.A. Model AB139 and AW139 helicopters with certain main rotor (M/R) rotating scissors installed. AD 2014-07-51 required repetitively inspecting the M/R rotating scissors for play of the lower half scissor spherical bearing (bearing) and removing the bearing if there was play beyond allowable limits. AD 2014-07-51 also required removing all affected bearings. AD 2014-07-51 was prompted by reports of certain bearings dislodging from certain M/R rotating scissors. This new AD retains the requirements of AD 2014-07-51, expands the applicability, and requires installing a special nut. These actions are intended to detect excessive play of the bearing and prevent failure of the M/R rotating scissors and subsequent loss of control of the helicopter.

The FAA is issuing this notice to advise the public of a meeting of RTCA Program Management Committee.

This action proposes to establish Class E Airspace at West Creek, NJ, to accommodate new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) serving Eagles Nest Airport. This action would enhance the safety and airspace management of Instrument Flight Rules (IFR) operations within the National Airspace System.

This action proposes to establish Class E Airspace at North Adams, MA, to accommodate new Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedures (SIAPs) serving Harriman-and-West Airport. This action would enhance the safety and airspace management of Instrument Flight Rules (IFR) operations within the National Airspace System.

We are revising an earlier proposed airworthiness directive (AD) for all Rolls-Royce plc (RR) RB211 Trent 875-17, 877-17, 884-17, 884B-17, 892-17, 892B-17, and 895-17 turbofan engines. The NPRM proposed to require modification of the engine by removing any electronic engine control (EEC) that incorporates EEC software standard prior to version B7.2 and installing an EEC eligible for installation. The NPRM was prompted by failure of the intermediate pressure (IP) turbine disk drive arm and subsequent overspeed and burst of the IP turbine disk on an RR RB211 Trent turbofan engine. This action revises the NPRM by clarifying the costs of compliance, by clarifying that correction of the unsafe condition can be achieved either by installing upgraded software in the EEC or by installing an EEC with upgraded software incorporated, and by clarifying the installation prohibition statement. We are proposing this supplemental NPRM (SNPRM) to prevent overspeed of the IP turbine disk, resulting in failure of the turbine blades or the IP turbine disk and subsequent uncontained release of the disk and/or turbine blades, which could lead to damage to the engine and damage to the airplane.

We are superseding Airworthiness Directive (AD) 2012-06-19 for certain Airbus Model A330-201, -202, -203, -223, -243, -301, -302, - 303, -321, -322, -323, -341, -342, and -343 airplanes; and Model A340- 200 and -300 series airplanes. AD 2012-06-19 required repetitive inspections of the main fitting and sliding tube of the nose landing gear (NLG) for defects, damage, and cracks; and corrective actions if necessary. This new AD requires an inspection of the part number and serial number of the NLG main fitting and NLG sliding tube; for affected parts, this new AD requires a magnetic particle inspection (MPI) for cracks, and flap peening and replacement if necessary. This new AD also requires, for certain parts, additional inspections for damage and cracking. This new AD also adds airplanes to the applicability. This AD was prompted by reports of a cracked main fitting and sliding tube during NLG overhaul. We are issuing this AD to detect and correct cracks, defects, or damage of the main fitting or sliding tube, which could result in consequent NLG collapse.

We are superseding Airworthiness Directive (AD) 2005-13-05, which applied to certain Boeing Model 747-400F series airplanes. AD 2005-13-05 required inspections for cracking of the web, upper chord, and upper chord strap of the upper deck floor beams, and repair of any cracking. AD 2005-13-05 also required a preventive modification of the upper deck floor beams, and repetitive inspections for cracking after accomplishing the modification. This new AD retains these actions and requires a second modification, repetitive inspections for cracking, and repair if necessary. This AD was prompted by a determination that the upper chords of the upper deck floor beams at certain stations are structures that are susceptible to widespread fatigue damage, and that certain airplanes with an initial modification require a second modification for the airplane to meet its limit of validity (LOV). We are issuing this AD to detect and correct fatigue cracking in certain upper chords of the upper deck floor beam, which could result in reduced structural integrity of the airplane and rapid decompression or reduced controllability of the airplane.

We are superseding Airworthiness Directive (AD) 2004-16-01 for certain Airbus Model A330-200 and -300 series airplanes and Model A340- 200 and -300 series airplanes. AD 2004-16-01 required repetitive inspections for cracking of the chromed area of the left and right piston rods for the main landing gear (MLG) retraction actuators, and related investigative and corrective actions if necessary. This new AD requires repetitive draining of any fluid from the retraction actuator piston rod internal volume and sealing of the vent hole; repetitive ultrasonic inspections of the upper end of the piston rods, and corrective actions if necessary; a one-time ultrasonic inspection (longitudinal and circumferential) of the full length of the piston rod, and corrective actions if necessary; and a terminating modification of the left-hand and right-hand MLG retraction actuators. This AD was prompted by reports of the piston rods for the MLG retraction actuators rupturing during flight. We are issuing this AD to prevent cracking of the piston rods for the MLG retraction actuators, which could result in rupture of a piston rod, non-damped extension of the MLG, high loads on the fully extended MLG, and consequent reduced structural integrity of the MLG.

The FAA has completed its review of the application for an airport noise and access restriction submitted by Los Angeles World Airports (LAWA) for the Los Angeles International Airport (LAX). The FAA determined that the application does not provide substantial evidence that the proposed restriction meets three of the six statutory conditions for approval under the Airport Noise and Capacity Act of 1990 (ANCA). The FAA's decision was signed on November 7, 2014, and transmitted to LAWA on November 8, 2014.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on September 9, 2014. The information is used to determine if applicants satisfy requirements for obtaining a launch license to protect the public from risks associated with reentry operations from a site not operated by or situated on a Federal launch range.

The FAA publishes a monthly notice, as appropriate, of PFC approvals and disapprovals under the provisions of the Aviation Safety and Capacity Expansion Act of 1990 (Title IX of the Omnibus Budget Reconciliation Act of 1990) (Pub. L. 101-508) and Part 158 of the Federal Aviation Regulations (14 CFR part 158). This notice is published pursuant to paragraph d of Sec. 158.29.

The FAA is issuing this notice to advise the public of a meeting of the ARAC.

We are superseding airworthiness directive (AD) 2013-15-09 for all Pratt & Whitney Division (PW) PW4074, PW4074D, PW4077, PW4077D, PW4084D, PW4090, and PW4090-3 turbofan engine models with certain second-stage high-pressure turbine (HPT) air seals installed. AD 2013- 15-09 required initial and repetitive inspections for cracks in second- stage HPT air seals. This new AD expands the applicability of AD 2013- 15-09 to include additional part numbers (P/Ns), requires removal of the mating hardware if the second-stage HPT air seal is found with a through-crack, and adds a mandatory terminating action. This AD was prompted by reports of cracking in the original location on two additional P/Ns and reports of through-cracks in a new location in the second-stage HPT air seal. We are issuing this AD to prevent failure of the second-stage HPT air seal, which could lead to uncontained engine failure and damage to the airplane.

The Federal Aviation Administration (FAA) proposes to rule and invites public comment on the application for a release of 23,974 square feet (approximately .55 acres) of airport property at Reno-Tahoe International Airport, Reno, Nevada from all conditions contained in the Grant Assurances since the parcel of land is not needed for airport purposes. The property consists of narrow strip of land approximately 25 feet wide by 850 feet long. The property is located approximately 2,500 feet east of the departure end of Reno-Tahoe Airport Runway 7/25. The property is separated from the airport operations area to the west by a public road and several non-aeronautical leaseholds and parking lots. The east side of the property is adjacent to East McCarran Boulevard. The Reno-Tahoe Airport Authority (RTAA) and the Nevada Department of Transportation propose to use the land to widen East McCarran Boulevard, a major arterial road that serves the Reno/Sparks Communities. The widening of the road represents a compatible land use that will not interfere with the airport or its operation. The interest of civil aviation continues to be served by the release. The property will be sold at an appraised fair market value to the State of Nevada, Department of Transportation and the proceeds deposited in the airport account.

This action proposes to establish Class E airspace at Tribune, KS. Controlled airspace is necessary to accommodate new Standard Instrument Approach Procedures (SIAPs) at Tribune Municipal Airport. The FAA is taking this action to enhance the safety and management of Instrument Flight Rules (IFR) operations for SIAPs at the airport.

We are adopting a new airworthiness directive (AD) for all Airbus Model A318 series airplanes, Model A319 series airplanes, Model A320-211, -212, -214, -231, -232, and -233 airplanes, and Model A321 series airplanes. This AD was prompted by a report of a circumferential crack at the gland retaining-ring groove of certain retraction actuators on the main landing gear (MLG). This AD requires an inspection to identify the part numbers of MLG retraction actuators and replacement of certain MLG retraction actuators. We are issuing this AD to prevent MLG retraction actuator failure that could prevent the full extension and/or down-locking of the MLG, possibly resulting in MLG collapse during landing or rollout, and consequent damage to the airplane and injury to the occupants.

We are adopting a new airworthiness directive (AD) for certain Agusta Model A109E, A109K2, A119, and AW119 MKII helicopters. This AD requires repetitively performing a magnetic particle inspection of the Gleason crown for a crack. This AD was prompted by a report of a crack that was found on a Gleason crown, which if not detected, could cause damage to or loss of the main rotor drive and subsequent loss of control of the helicopter.

This action proposes to establish Class E airspace at Spokane, WA, to facilitate vectoring of Instrument Flight Rules (IFR) aircraft under control of Seattle Air Route Traffic Control Center (ARTCC). The FAA is proposing this action to enhance the safety and management of IFR operations within the National Airspace System (NAS).

The FAA is issuing this notice to advise the public of the second meeting of RTCA Special Committee 232, Airborne Selective Calling Equipment.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval for to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on September 9, 2014. Special Airworthiness Information Bulletins (SAIBs) alert, educate, and make recommendations to the aviation community and aircraft owners/operators on ways to improve products, and may include requests for reporting results from requested actions and inspections.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on September 9, 2014. The information to be collected includes data required for performing launch site location analysis. The launch site license is valid for a period of 5 years. Respondents are licensees authorized to operate sites.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on September 9, 2014. One of the ways to have an information program designated as protected under Section 40123 is for an air carrier or other person to submit an application for an individual program. The FAA evaluates the application and either publishes a designation based on the application for public comment or denies the application.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.