Federal Aviation Administration November 28, 2014 – Federal Register Recent Federal Regulation Documents
Results 1 - 4 of 4
Airworthiness Directives; The Boeing Company Airplanes
We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 airplanes. This proposed AD was prompted by numerous reports of failures of the proximity sensor within the slat skew detection mechanism assembly (DMA) leading to slats up landing events. This proposed AD would require replacing the slat skew DMAs with new slat skew DMAs, and marking the existing identification plates on the slat with the new part number. We are proposing this AD to prevent failure of the proximity sensor, which could result in the slats being shut down and a slats up high speed landing. This condition, in combination with abnormal landing conditions such as a short runway or adverse weather conditions, could result in a runway excursion.
Airworthiness Directives; The Boeing Company Airplanes
We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 747-100B, 747-100B SUD, 747-200B, 747- 200C, 747-200F, 747-300, 747-400, 747-400D, 747-400F, 747SR, and 747SP series airplanes. This proposed AD was prompted by reports of corrosion found on the mating surfaces between certain skin and stringers at circumferential skin splices. This proposed AD would require general visual inspections of the fuselage skin at certain lower circumferential splices for the presence of existing external doublers, repetitive inspections of the fuselage skin, and related investigative and corrective actions if necessary. We are proposing this AD to detect and correct compromised fillet seals, which can result in corrosion and skin cracking and consequent loss of capability to support limit loads.
Airworthiness Directives; Agusta S.p.A. Helicopters
We are superseding Airworthiness Directive (AD) 2014-07-51 for AgustaWestland S.p.A. Model AB139 and AW139 helicopters with certain main rotor (M/R) rotating scissors installed. AD 2014-07-51 required repetitively inspecting the M/R rotating scissors for play of the lower half scissor spherical bearing (bearing) and removing the bearing if there was play beyond allowable limits. AD 2014-07-51 also required removing all affected bearings. AD 2014-07-51 was prompted by reports of certain bearings dislodging from certain M/R rotating scissors. This new AD retains the requirements of AD 2014-07-51, expands the applicability, and requires installing a special nut. These actions are intended to detect excessive play of the bearing and prevent failure of the M/R rotating scissors and subsequent loss of control of the helicopter.
Airworthiness Directives; The Boeing Company Airplanes
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model DC-8-55, DC-8F-54, and DC-8F-55 airplanes, Model DC-8-60 series airplanes, Model DC-8-60F series airplanes, Model DC-8-70 series airplanes, and Model DC-8-70F series airplanes. This AD was prompted by multiple reports of cracking of the upper aft skin panel of the fuselage. An evaluation by the design approval holder (DAH) indicates that the upper aft skin panel of the fuselage is subject to widespread fatigue damage (WFD). This AD requires removing any previously installed local repairs; installing a full-length improvement modification with or without finger doublers, or a full- length repair with or without finger doublers, as applicable; and doing repetitive inspections for cracking of the doublers, and repair if necessary. We are issuing this AD to detect and correct fatigue cracking of the upper aft skin panel of the fuselage, which could result in loss of structural integrity and consequent rapid decompression of the airplane.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
