Federal Aviation Administration July 1, 2013 – Federal Register Recent Federal Regulation Documents
Results 1 - 2 of 2
Airworthiness Directives; Airbus Airplanes
We propose to adopt a new airworthiness directive (AD) for all Airbus Model A318, A319, A320, and A321 series airplanes. This proposed AD was prompted by a determination that certain special washers used in the retraction jack anchorage fitting bearing installation in the main landing gear (MLG) were incorrectly manufactured. This proposed AD would require an inspection of the left-hand (LH) and right-hand (RH) MLG retraction jack anchorage fitting bearing assemblies to verify that the special washer is seated correctly, and related investigative and corrective actions if necessary. We are proposing this AD to detect and correct installation of incorrectly manufactured special washers, which could lead to a local stress concentration resulting in possible reduction of the fatigue life of the jack fitting, and consequent reduction of the structural integrity of the affected MLG.
Airworthiness Directives; The Boeing Company Airplanes
We propose to supersede an existing airworthiness directive (AD) that applies to all The Boeing Company Model 737-100, -200, -200C, -300, -400, and -500 series airplanes. The existing AD currently requires repetitive inspections for discrepancies of each carriage spindle of the outboard mid-flaps; repetitive gap checks of the inboard and outboard carriages of the outboard mid-flaps to detect fractured carriage spindles; measuring to ensure that any new or serviceable carriage spindle meets minimum allowable diameter measurements taken at three locations; repetitive inspections, measurements, and overhaul of the carriage spindles; replacement of any carriage spindle when it has reached its maximum life limit; and corrective actions if necessary. Since we issued that AD, we received a report of failure of both flap carriages. This proposed AD would require reducing the life limit of the carriages, reducing the repetitive interval for certain inspections and gap checks for certain carriages. This proposed AD would also add an option, for certain replacements, of doing an inspection, and related investigative and corrective actions if necessary. We are proposing this AD to detect and correct cracked, corroded, or fractured carriage spindles, which could lead to severe flap asymmetry, and could result in reduced control or loss of controllability of the airplane.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.