Federal Aviation Administration December 27, 2012 – Federal Register Recent Federal Regulation Documents
Results 1 - 3 of 3
Airworthiness Directives; GA200 (Pty) Ltd Airplanes
We are revising an existing airworthiness directive (AD) for all GA200 (Pty) Ltd Models GA200 and GA200C airplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as failure of the wing strut bolt through the main spar. We are issuing this AD to require actions to address the unsafe condition on these products.
Airworthiness Directives; Airbus Airplanes
We are adopting a new airworthiness directive (AD) for all Airbus Model A330-300 series airplanes and Model A340-200 and -300 series airplanes. This AD was prompted by reports that, during a flight test, several spoiler servo-controls (SSCs) did not remain locked in the retracted position (hydraulic locking function) after manual depressurization of the corresponding hydraulic circuit. Loss of that locking functionwhich is ensured by a blocking valvewas caused by an internal leak from a sheared seal on the blocking valve. This AD requires inspecting to determine if certain SSCs are installed, performing an operational test of any affected SSC, and replacing if necessary. We are issuing this AD to prevent loss of the hydraulic locking function during take-off and go-around phases, which, in combination with malfunction of one engine, could result in reduced controllability of the airplane.
Airworthiness Directives; The Boeing Company Airplanes
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 737-600, -700, -700C, -800, -900, and -900ER series airplanes. This AD was prompted by reports of escape slides failing to deploy from the forward and aft right-hand doors during scheduled maintenance slide deployments. This AD requires modifying the escape slide. Also, for certain airplanes, this AD requires modifying or replacing the Vespel piston. For certain other airplanes, this AD requires an additional modification of the escape slide. We are issuing this AD to prevent failure of an escape slide to deploy, which could result in the slide being unusable during an emergency evacuation and increased likelihood of injury to passengers or crewmembers due to the difficulty in evacuating the airplane.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
