Federal Aviation Administration November 9, 2012 – Federal Register Recent Federal Regulation Documents

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of the FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This action proposes special conditions for the Embraer S.A. Model EMB-550 airplane. This airplane will have a novel or unusual design feature(s) associated with the use of an Automatic Takeoff Thrust Control System (ATTCS) during go-around. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These proposed special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

We are adopting a new airworthiness directive (AD) for all Airbus Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model A300 C4-605R Variant F airplanes (collectively called A300-600 series airplanes); and Model A310 series airplanes. This AD was prompted by events of excessive rudder pedal inputs and consequent high loads on the vertical stabilizer on several airplanes. This AD requires either incorporating a design change to the rudder control system and/ or other systems, or installing a stop rudder inputs warning (SRIW) modification. We are issuing this AD to prevent loads on the vertical stabilizer that exceed ultimate design loads, which could cause failure of the vertical stabilizer and consequent reduced controllability of the airplane.

We are adopting a new airworthiness directive (AD) for Aeronautical Accessories, Inc. (AAI) high landing gear forward crosstube assemblies (crosstubes) installed on Agusta S.p.A. (Agusta) Model AB412 and AB412EP; and Bell Helicopter Textron, Inc. (Bell) Model 205A, 205A-1, 205B, 212, 412, 412CF, and 412EP helicopters during production or based on a supplemental type certificate (STC). This AD requires counting and recording the total number of landings for the crosstubes, and inspecting the crosstubes and replacing them if a crack or other damage exists. This AD was prompted by two reports from the field of failed crosstubes. The actions are intended to prevent failure of a crosstube, collapse of the landing gear, and subsequent loss of control of the helicopter.

We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400, -401, and -402 airplanes. This AD was prompted by reports of an in-service incident where the propeller de- icing system became unavailable due to burnt/chafed wires within the alternating current contactor box (ACCB). This AD requires inspection for chafing, damage, and loose wiring within an ACCB and repair if necessary; and requires rework and re-identification of the wiring installation within each ACCB. We are issuing this AD to detect and correct damaged, chafed, or loose wiring within an ACCB, which could affect the operation of the windshield heater, ice detector, angle of attack (AOA) vane heater, pilot probe heater, engine intake heater, or propeller de-icing system, and subsequently adversely affect the airplane's flight characteristics in icing conditions.