Federal Aviation Administration May 13, 2009 – Federal Register Recent Federal Regulation Documents
Results 1 - 6 of 6
Airworthiness Directives; Cessna Aircraft Company 150 and 152 Series Airplanes
The FAA is adopting a new airworthiness directive (AD) for Cessna Aircraft Company (Cessna) 150 and 152 series airplanes. This AD requires you to either install a placard prohibiting spins and other acrobatic maneuvers in the airplane or to replace the rudder stop, rudder stop bumper, and attachment hardware with a new rudder stop modification kit and replace the safety wire with jamnuts. This AD results from follow-on investigations of two accidents where the rudder was found in the over-travel position with the stop plate hooked over the stop bolt heads. While neither of the accident aircraft met type design, investigations revealed that aircraft in full conformity with type design can exceed the travel limits set by the rudder stops. We are issuing this AD to prevent the rudder from traveling past the normal travel limit. Operation in this non-certificated control position is unacceptable and could cause undesirable consequences, such as contact between the rudder and the elevator.
Airworthiness Directives; Bombardier Model CL-600-2B19 (Regional Jet Series 100 and 440) Airplanes
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Pratt & Whitney Models PW2037, PW2037(M), and PW2040 Turbofan Engines
The FAA is adopting a new airworthiness directive (AD) for Pratt & Whitney models PW2037, PW2037(M), and PW2040 turbofan engines with high-pressure turbine (HPT) 2nd stage hubs that have previously been exposed to Pratt & Whitney cleaning procedure SPOP 10 or SPOP 9 or equivalent procedure. This AD requires a onetime optical comparator inspection (OCI) of the blade retention slots of the affected HPT 2nd stage hubs at the next HPT overhaul after the effective date of the AD. This AD results from an uncontained release of HPT 2nd stage blades and blade retention lugs. We are issuing this AD to remove nonconforming HPT 2nd stage hubs, which could result in an uncontained release of turbine blades and blade retention lugs, and damage to the airplane.
Airworthiness Directives; Boeing Model 747-400 and 747-400D Series Airplanes
We are adopting a new airworthiness directive (AD) for certain Boeing Model 747-400 and 747-400D series airplanes. This AD requires repetitive inspections to detect cracks in the floor panel attachment fastener holes of the Section 41 upper deck floor beam upper chords, and related investigative and corrective actions if necessary. This AD results from reports of cracks found in the Section 41 upper deck floor beam upper chords. We are issuing this AD to detect and correct cracks in these chords, which could become large and cause the floor beams to become severed and result in rapid decompression or reduced controllability of the airplane.
Airworthiness Directives; Airbus Model A380-841, -842, and -861 Airplanes
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Diamond Aircraft Industries GmbH Model DA 40 and DA 40 F Airplanes
We are adopting a new airworthiness directive (AD) for the products listed above to supersede an existing AD. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
