Federal Aviation Administration August 13, 2008 – Federal Register Recent Federal Regulation Documents

The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 206: Aeronautical Information Services Data Link.

The FAA invites public comments about our intention to request the Office of Management and Budget's (OMB) revision of a current information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on May 15, 2008, vol. 73, no. 95, pages 28183-28184. SFAR 36 (to part 121) relieves qualifying applicants involved in aircraft repair of the burden to obtain FAA approval of data developed by them for the major repairs on a case-by-case basis; and provides for one-time approvals.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is superseding an existing airworthiness directive (AD), which applies to certain Boeing Model 747 series airplanes. That AD currently requires inspecting to detect cracking in certain lower lobe fuselage skin lap joints, doing repetitive inspections for cracking at certain fastener locations having countersunk fasteners, and replacing countersunk fasteners with protruding head fasteners at certain fastener locations. This new AD requires replacing a previous high-frequency eddy current (HFEC) inspection method with a new HFEC inspection method, adding a one-time inspection for cracking of certain airplanes, and terminating the adjustment factor for the inspection compliance times based on cabin differential pressure. This AD also requires inspecting additional lap joints. This AD results from reports of fuselage skin cracks found at certain countersunk fastener locations in the upper row of lap joints near the wing-to-body fairings, and from a report that the presence of Alodine-coated rivets could cause faulty results during the required inspections using the optional sliding probe HFEC inspection method specified in the existing AD. We are issuing this AD to prevent reduced structural integrity of the fuselage.