Federal Aviation Administration October 27, 2006 – Federal Register Recent Federal Regulation Documents

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as unsatisfactory initial elevator trim actuator greasing, which may lead to the icing of the elevator trim and generate an untrimmed nose-up attitude after an autopilot disconnection. We are issuing this AD to require actions to correct the unsafe condition on these products.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as a failure in the flap actuating circuit. An investigation showed that the lever at the torsional drive in the fuselage failed at the weld. We are issuing this AD to require actions to correct the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all Airbus Model A300 and A310 airplanes and A300-600 series airplanes. This AD requires inspecting for discrepancies of all electrical bundles located in the leading and trailing edges of the wings, and performing corrective actions if necessary. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent an ignition source, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.

The FAA is superseding an existing airworthiness directive (AD), which applies to various aircraft equipped with certain Honeywell Primus II RNZ-850( )/-851( ) integrated navigation units (INUs). That AD, as one alternative for compliance, provides for a one-time inspection to determine whether a certain modification has been installed on the Honeywell Primus II NV-850 navigation receiver module (NRM), which is part of the INU. In lieu of accomplishing this inspection, and for aircraft found to have an affected NRM, the existing AD provides for revising the aircraft flight manual to include new limitations for instrument landing system approaches. This new AD requires inspecting to determine whether certain modifications have been done on the NRM; and doing related investigative, corrective, and other specified actions, as applicable; as well as further modifications to address additional anomalies. This AD results from reports indicating that erroneous glideslope indications have occurred on certain aircraft equipped with the subject INUs. We are issuing this AD to ensure that the flightcrew has an accurate glideslope deviation indication. An erroneous glideslope deviation indication could lead to the aircraft making an approach off the glideslope, which could result in impact with an obstacle or terrain.

The FAA is adopting a new airworthiness directive (AD) for certain Boeing Model 757-200, -200CB, and -300 series airplanes. This AD requires repetitive detailed inspections for proper functioning of the girt bar leaf springs for the escape slides to ensure the leaf springs retain the sliders and the required 0.37-inch minimum engagement between the sliders and floor fittings is achieved at passenger doors 1, 2, and 4, and corrective actions if necessary. This AD results from a report that the escape slides failed to deploy correctly during an operator's tests of the escape slides. We are issuing this AD to prevent escape slides from disengaging from the airplane during deployment or in use, which could result in injuries to passengers or flightcrew.