Federal Aviation Administration January 3, 2005 – Federal Register Recent Federal Regulation Documents
Results 1 - 5 of 5
Airworthiness Directives; Boeing Model 747-200B, 747-200C, 747-200F, 747-300, and 747SR Series Airplanes Equipped with General Electric (GE) CF6-45 or -50 Series Engines
The FAA proposes to adopt a new airworthiness directive (AD) for certain Boeing Model 747-200B, 747-200C, 747-200F, 747-300, and 747SR series airplanes, equipped with GE CF6-45 or -50 series engines. This proposed AD would require modifying the side cowl assemblies on the engines by replacing existing wear plates with new extended wear plates and installing new stop fittings. This proposed AD is prompted by reports of a gap at the interface of the lower portion of the side cowl and the aft flange of the thrust reverser. We are proposing this AD to prevent an excessive quantity of air from entering the fire zone that surrounds the engine, which in the event of an engine fire, could result in an inability to control or extinguish the fire.
Airworthiness Directives; Boeing Model 767-200, -300, and -300F Series Airplanes
This document corrects an error that appeared in airworthiness directive (AD) 2004-22-25, which was published in the Federal Register on November 9, 2004 (69 FR 64839). The error resulted in the incorrect reference to cable spacers. This AD is applicable to certain Boeing Model 767-200, -300, and -300F series airplanes. This AD requires a one-time inspection for discrepancies of all wire bundles, including certain power feeder cables, of the electrical system in the forward cargo compartment ceiling at certain stations; and corrective actions if necessary.
Airworthiness Directives; Saab Model SAAB SF340A and SAAB 340B Series Airplanes
This document corrects a typographical error that appeared in airworthiness directive (AD) 2004-24-06 that was published in the Federal Register on November 30, 2004 (69 FR 69505). The typographical error resulted in incorrect reference to certain main landing gear (MLG) part numbers as retract actuator bracket attachment bolt (RABAB) part numbers. This AD is applicable to certain Saab Model SAAB SF340A and SAAB 340B series airplanes. This AD requires replacement of the RABAB of the MLG with a new RABAB; reidentification of the MLG shock strut; an inspection for corrosion, fretting, or other damage of certain RABABs; and applicable corrective actions.
Airworthiness Directives; Bell Helicopter Textron Canada Model 222, 222B, 222U, 230, and 430 Helicopters
This amendment adopts a new airworthiness directive (AD) for the specified Bell Helicopter Textron (BHTC) model helicopters. This action requires certain checks and inspections of the tail rotor blades. If a crack is found, before further flight, this AD requires replacing the tail rotor blade (blade) with an airworthy blade. This amendment is prompted by three reports of cracked blades found during scheduled inspections. The actions specified in this AD are intended to detect a crack in the blade and prevent loss of a blade and subsequent loss of control of the helicopter.
Cape Town Treaty Implementation
The FAA is revising the regulations concerning registering aircraft and recording security documents. The Cape Town Treaty establishes a new International Registry for registering interests against certain aircraft and aircraft engines. Section 4 of the Cape Town Treaty Implementation Act of 2004 requires the FAA to make certain changes. This action will enable persons to transmit information to the new International Registry concerning certain aircraft and aircraft engines by making the FAA Aircraft Registry the U.S. authorizing entry point to the International Registry. We are also making unrelated technical changes to other portions of the regulations in this document.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
