Department of Transportation December 30, 2021 – Federal Register Recent Federal Regulation Documents

The FAA is superseding airworthiness directive (AD) 2021-24- 06, which applied to certain Airbus Helicopters Model EC130T2 helicopters. AD 2021-24-06 required repetitive visual inspections of the rivets on the rear transmission shaft bearing support and of the local structure for cracking and missing, loose, or sheared rivets and accomplishment of applicable corrective actions. This AD retains those requirements and adds repetitive visual inspections of the rivet heads on the left-hand and right-hand sides of the rear transmission shaft bearing support, revises a corrective action, and adds a reporting requirement, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD also revises the special flight permit limitation from AD 2021-24-06. This AD was prompted by an additional report of loose rivet heads on the outside face of the tail boom corner support. The FAA is issuing this AD to address the unsafe condition on these products.

The National Highway Traffic Safety Administration (NHTSA) invites public comments about our intention to request approval from the Office of Management and Budget (OMB) for an extension of a currently approved information collection. Before a Federal agency may collect certain information from the public, it must receive approval from OMB. Under procedures established by the Paperwork Reduction Act of 1995, before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatements of previously approved collections. This document describes a collection of information for which NHTSA intends to seek OMB approval to allow NHTSA to continue to conduct research on the development of a driver alcohol detection system. NHTSA is seeking an extension of the information collection, titled ``Driver Alcohol Detection System for Safety Field Operational Test'' (OMB Control Number 2127-0734), which is currently approved through March 31, 2022. The extension is necessary to complete data collection that was delayed due to COVID-19 restrictions. The burden hour and cost calculations have been adjusted to reflect only the remaining data collection, adjustments for recruitment based on current experience, and adjustments in participation based on current experience.