Department of Transportation November 24, 2021 – Federal Register Recent Federal Regulation Documents

Reshaping the United States transportation system with electric vehicle (EV) charging infrastructure is an important part of the solution to the climate crisis. EV charger manufacturing, assembly, installation, and maintenance all have the potential to not only support policies on sustainability and climate, but also to create good-paying, union jobs in the United States. This RFI is intended to gather information on shifting manufacturing and assembly processes to the United States considering the bold investment planned in EV charging. DOT and DOE (the Agencies) are interested in hearing from the public, including stakeholders (such as State and local agencies, the EV charger manufacturing industry, component suppliers, labor unions, related associations, and transportation advocates), on the availability of EV chargers manufactured and assembled in the United States, including whether they comply with applicable Buy America requirements.

FMCSA announces receipt of applications from 11 individuals for an exemption from the vision requirement in the Federal Motor Carrier Safety Regulations (FMCSRs) to operate a commercial motor vehicle (CMV) in interstate commerce. If granted, the exemptions will enable these individuals to operate CMVs in interstate commerce without meeting the vision requirement in one eye.

The FAA is adopting a new airworthiness directive (AD) for all Airbus SAS Model A350-941 and -1041 airplanes. This AD was prompted by a report of a broken forward guide arm found during a passenger door emergency opening test. Investigation results indicated that the opening speed of the door was higher than expected, likely caused by a reduced damping due to oil leakage of the passenger door damper emergency opening actuator (DEOA). This AD requires repetitively replacing certain forward and aft guide arms on the passenger door, inspecting the forward and aft guide arm support brackets for damage, modifying certain DEOAs, and repairing damage if necessary, and also provides an optional terminating action for the repetitive replacements, as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.

The FAA is adopting a new airworthiness directive (AD) for all Airbus Canada Limited Partnership Model BD-500-1A10 and BD-500-1A11 airplanes. This AD was prompted by a report of cracking in certain components on left and right sides of the aft wing-to-body fairing (WTBF) structure near the tie-rod attachment at a certain fuselage station; this cracking likely resulted from excessive tie-rod preload. This AD requires inspecting the aft WTBF structure for any cracking or damage, adjusting the load on the two tie-rods at a certain fuselage station, and repair if necessary, as specified in two Transport Canada Civil Aviation (TCCA) ADs, which are incorporated by reference. The FAA is issuing this AD to address the unsafe condition on these products.