Department of Transportation August 30, 2019 – Federal Register Recent Federal Regulation Documents

These special conditions are issued for the DAHER Aerospace Model TBM700 airplane. This airplane will have a novel or unusual design feature associated with the use of an autothrust system. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

On August 12, 2016, FRA published a final rule requiring commuter and intercity passenger railroads to develop and implement a system safety program (SSP) to improve the safety of their operations. FRA has stayed the SSP final rule's requirements until September 4, 2019. FRA is issuing this final rule to extend that stay until March 4, 2020.

Before a Federal agency can collect certain information from the public, it must receive approval from the Office of Management and Budget (OMB). Under procedures established by the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), before seeking OMB approval, Federal agencies must solicit public comment on proposed collections of information, including extensions and reinstatements of previously approved collections. This document describes an Information Collection Request (ICR) for which NHTSA intends to seek OMB approval.

The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus SAS Model A350-941 airplanes. This proposed AD was prompted by the results of a structural analysis, which identified that the upper frame fittings (UFF) of the forward cargo door surrounding structure have a low fatigue life. This proposed AD would require repetitive inspections of the forward cargo door UFF and brackets for discrepancies and, depending on the findings, doing applicable corrective actions, as specified in a European Union Aviation Safety Agency (EASA) AD, which will be incorporated by reference. The FAA is proposing this AD to address the unsafe condition on these products.

The FAA proposes to adopt a new airworthiness directive (AD) for all Fokker Services B.V. Model F28 Mark 0070 and 0100 airplanes. This proposed AD was prompted by reports of lavatory waste bin fire extinguishers found depleted. This proposed AD would require a one-time inspection of the installation of the waste bins for interference (the inspection also includes a weight check of the waste bin fire extinguisher and an inspection of the discharge tubes for damage), modification of affected waste bins, and replacement of affected fire extinguishers, as specified in a European Union Aviation Safety Agency (EASA) AD, which will be incorporated by reference. This proposed AD would also require replacement of the fire extinguisher if any damaged discharge tube is found or the weight of the waste bin fire extinguisher is too low. The FAA is proposing this AD to address the unsafe condition on these products.

This action amends Title 14 Code of Federal Regulations (14 CFR) part 71 relating to airspace designations to reflect the approval by the Director of the Federal Register of the incorporation by reference of FAA Order 7400.11D, Airspace Designations and Reporting Points. This action also explains the procedures the FAA will use to amend the listings of Class A, B, C, D, and E airspace areas; air traffic service routes; and reporting points incorporated by reference.