Department of Transportation February 17, 2016 – Federal Register Recent Federal Regulation Documents
Results 1 - 16 of 16
Notice To Rescind Notice of Intent To Prepare Environmental Impact Statement, U.S. 219 Project, Garrett County, Maryland and Somerset County, Pennsylvania
The Federal Highway Administration is issuing this notice to advise the public that FHWA is rescinding its Notice of Intent to prepare an Environmental Impact Statement for the U.S. 219 project in Garrett County, Maryland and Somerset County, Pennsylvania.
Special Conditions: Dassault Aviation Model Falcon 5X Airplane, Design Roll Maneuver Condition
These special conditions are issued for the Dassault Aviation Model Falcon 5X airplane. This airplane will have novel or unusual design features when compared to the state of technology envisioned in the airworthiness standards for transport-category airplanes. This design feature is electronic flight controls that affect maneuvering. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.
Graco Children's Products, Inc., Receipt of Petition for Decision of Inconsequential Noncompliance
Graco Children's Products, Inc. (Graco), has determined that certain Graco Milestone child restraints manufactured between July 9, 2015 and October 6, 2015, do not fully comply with paragraph S5.5.2(g)(1)(ii) of Federal Motor Vehicle Safety Standard (FMVSS) No. 213, Child Restraint Systems. Graco filed a report pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports. Graco then petitioned NHTSA under 49 CFR part 556 requesting a decision that the subject noncompliance is inconsequential to motor vehicle safety.
Information Required in Notices and Petitions Containing Interchange Commitments
The Surface Transportation Board (STB or Board) is issuing a final rule to insert language that was inadvertently omitted when an amended rule was promulgated on September 5, 2013. This decision is effective on its date of publication.
Agency Information Collection Activities; Extension of a Currently Approved Collection: Driver Qualification Files
In accordance with the Paperwork Reduction Act of 1995, FMCSA announces its plan to submit the Information Collection Request (ICR) described below to the Office of Management and Budget (OMB) for its review and approval, and invites public comment. The Agency's regulations pertaining to the qualification of operators of commercial motor vehicles (CMVs) are unchanged and impose no increased information-collection (IC) burden on individual drivers and motor carriers. However, the Agency increases its estimate of the total IC burden of these regulations because both the number of CMV drivers and the frequency of their hiring have increased since the Agency's 2012 estimate of this burden.
Electronic Logging Devices Compliance Testing Procedures: Public Listening Session
FMCSA will hold an online public listening session concerning the electronic logging device (ELD) compliance test procedures. This meeting will be a forum for providers of ELDs to give feedback to the Agency on the non-binding procedures used to determine if an ELD meets the specifications of the ELD rulemaking published on December 16, 2015. This online meeting is open to the public for its entirety.
Agency Information Collection Activities; Extension of a Currently-Approved Information Collection Request: Information Technology Services Survey Portal Customer Satisfaction Assessment (formerly COMPASS Portal Consumer Satisfaction Assessment)
In accordance with the Paperwork Reduction Act of 1995, FMCSA announces its plan to submit the Information Collection Request (ICR) described below to the Office of Management and Budget (OMB) for its review and approval and invites public comment. The collection involves an extension to a currently-approved ICR, and includes the assessment of FMCSA's strategic decision to integrate its Information Technology (IT) with its business processes using portal technology to consolidate its systems and databases through the FMCSA Information Technology Services Survey modernization initiative. The information to be collected will be used to assess the satisfaction of Federal, State, and industry customers with the FMCSA Information Technology Services Survey Portal. The name of the ``COMPASS Portal Customer Satisfaction Assessment,'' ICR was previously changed to ``Information Technology Services Survey Portal Customer Satisfaction Assessment,'' to reflect the need for a broader term than ``COMPASS'' for the portal. On October 27, 2015, FMCSA published a Federal Register notice (80 FR 65847) allowing for a 60-day comment period on this ICR. The agency received no comments in response to that notice.
Aston Martin Lagonda Limited, Receipt of Petition for Decision of Inconsequential Noncompliance
Aston Martin Lagonda Limited (AML), has determined that certain model year (MY) 2009-2015 Aston Martin DB9 two-door and four- door passenger cars do not fully comply with paragraph S4.3 of Federal Motor Vehicle Safety Standard (FMVSS) No. 206, Door locks and door retention components. Aston Martin Lagonda of North America, Inc., filed a report dated December 16, 2015, pursuant to 49 CFR part 573, Defect and Noncompliance Responsibility and Reports for AML. AML then petitioned NHTSA under 49 CFR part 556 requesting a decision that the subject noncompliance is inconsequential to motor vehicle safety.
Airworthiness Directives; Airbus Airplanes
We propose to adopt a new airworthiness directive (AD) for all Airbus Model A318, A319, A320, and A321 series airplanes. This proposed AD was prompted by a report of a partial loss of the no-back brake (NBB) efficiency during endurance qualification tests on the trimmable horizontal stabilizer actuator (THSA). This proposed AD would require inspecting certain THSAs to determine the number of total flight cycles the THSA has accumulated, and replacing the THSA if necessary. We are proposing this AD to prevent premature wear of the carbon friction disks on the NBB of the THSA, which could lead to reduced braking efficiency in certain load conditions, and, in conjunction with the inability of the power gear train to keep the ball screw in its last commanded position, could result in uncommanded movements of the trimmable horizontal stabilizer and loss of control of the airplane.
Establishment of Class E Airspace; International Falls, MN
This action establishes Class E airspace in the International Falls, MN, area to facilitate vectoring of Instrument Flight Rules (IFR) aircraft under control of Minneapolis Air Route Traffic Control Center (ARTCC). This action enhances the safety and efficiency of aircraft operations within the National Airspace System (NAS).
Proposed Amendment of Class E Airspace for the Following South Dakota Towns: Belle Fourche, SD; Madison, SD; Mobrigde, SD; and Vermillion, SD
This action proposes to modify Class E airspace extending upward from 700 feet above the surface at Belle Fourche Municipal Airport, Belle Fourche, SD; Madison Municipal Airport, Madison, SD; Mobridge Municipal Airport, Mobridge, SD; and Harold Davidson Field, Vermillion, SD. The decommissioning of non-directional radio beacons (NDB) and/or cancellation of NDB approaches due to advances in Global Positioning System (GPS) capabilities have made this action necessary for the safety and management of Instrument Flight Rules (IFR) operations at the above airports.
Proposed Establishment of Class E Airspace; Dupree, SD
This action proposes to establish Class E en route domestic airspace in the Dupree, SD, area, to facilitate vectoring of Instrument Flight Rules (IFR) aircraft under control of Minneapolis Air Route Traffic Control Center (ARTCC). The FAA is proposing this action to enhance the safety and efficiency of aircraft operations within the National Airspace System (NAS).
Proposed Establishment of Class E Airspace; Lisbon, ND
This action proposes to establish Class E airspace at Lisbon, ND. Controlled airspace is necessary to accommodate new Standard Instrument Approach Procedures developed at Lisbon Municipal Airport, for the safety and management of Instrument Flight Rules (IFR) operations at the airport.
Amendment of Air Traffic Service (ATS) Routes; Northeast United States
This action modifies jet routes J-6, J-97, and J-222, and VOR Federal airways V-196, and V-489, in the northeastern United States due to the planned decommissioning of the Plattsburgh, NY, VORTAC facility. These route changes enhance the safety and management of airspace within the National Airspace System.
Requested Administrative Waiver of the Coastwise Trade Laws: Vessel TEMOANANUIAKIVA; Invitation for Public Comments
As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.
Airworthiness Directives; The Boeing Company Airplanes
We are superseding Airworthiness Directive (AD) 2012-18-05 for The Boeing Company Model DC-9-10, DC-9-20, DC-9-30, DC-9-40, and DC-9- 50 series airplanes; and Model DC-9-81 (MD-81), DC-9-82 (MD-82), DC-9- 83 (MD-83), DC-9-87 (MD-87), MD-88, and MD-90-30 airplanes; equipped with a center wing fuel tank and Boeing original equipment manufacturer-installed auxiliary fuel tanks. AD 2012-18-05 required adding design features to detect electrical faults and to detect a pump running in an empty fuel tank. Since we issued AD 2012-18-05, we have determined that it is necessary to clarify the actions for airplanes on which the auxiliary fuel tanks are removed. This new AD allows certain actions as optional methods of compliance. This AD was prompted by our determination that it is necessary to clarify the actions for airplanes on which the auxiliary fuel tanks are removed. We are issuing this AD to reduce the potential of ignition sources inside fuel tanks, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.