Department of Transportation November 7, 2012 – Federal Register Recent Federal Regulation Documents

The FHWA is issuing this notice to advise the public that the Notice of Intent to prepare an Environmental Impact Statement (EIS) for the proposed State Route 75/282 Transportation Corridor Project in the city of Coronado in San Diego County, California (Federal Register Vol. 72, No 10; FR Doc E7-491) will be withdrawn.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

We propose to adopt a new airworthiness directive (AD) for certain serial number Pratt & Whitney Canada Corp. (P&WC) PW206B, PW206B2, PW206C, PW207C, PW207D, PW207D1, PW207D2, and PW207E turboshaft engines. This proposed AD was prompted by the discovery that certain power turbine (PT) disks were made to specific heat codes that may not achieve the maximum in-service life. This proposed AD would require re-identification of the PT disk to a part number (P/N) with a lower life limit. We are proposing this AD to prevent possible uncontained PT disk failure and loss of helicopter control.

We propose to supersede an existing airworthiness directive (AD) that applies to certain The Boeing Company Model 737-200, -200C, - 300, -400 and -500 series airplanes. The existing AD currently requires a one-time mid-frequency eddy current (MFEC) inspection, a low frequency eddy current (LFEC) inspection, and a detailed inspection for damage or cracking of stringer S-4L and S-4R lap joints and stringer clips between body station (BS) 540 and BS 727, and follow-on inspections and repair if necessary. Since we issued that AD, we have received reports of cracking of the lap joint lower row. This proposed AD would instead require repetitive external eddy current inspections for cracking of certain fuselage crown lap joints and corrective actions; internal eddy current and detailed inspections for cracking of certain fuselage crown lap joints, and repair if necessary; and detailed inspections of certain stringer clips, and replacement with new stringer clips if necessary. This proposed AD would also add airplanes to the applicability. We are proposing this AD to detect and correct cracking of the fuselage lap joints, which could result in sudden decompression of the airplane.

We propose to adopt a new airworthiness directive (AD) for certain Model A330-200, -300 and -200 Freighter series airplanes; and all Model A340-200 and -300 series airplanes. This proposed AD was prompted by a determination that the bonding lead from a certain isolation valve to a frame was too close to an electrical harness, which might cause chafing between the electrical harness and the associated bonding lead. This chafing could lead to a short circuit of the isolation valve and consequent non-closure of the isolation valve, which would prevent the air-flow to be shut-off in case of fire. This proposed AD would require modifying the bonding lead installation of the isolation valve. We are proposing this AD to prevent such chafing, which could result in non-closure of the isolation valve in the event of a fire and consequent damage to the airplane and injury to its occupants.

We propose to adopt a new airworthiness directive (AD) for certain Rolls-Royce Deutschland Ltd & Co KG (RRD) BR700-710 series turbofan engines. This proposed AD was prompted by service experience that demonstrated premature wear of the splined coupling on the fuel pump. This proposed AD would require replacement of the affected fuel pump splined couplings. We are proposing this AD to prevent failure of the engine and loss of the airplane.