Department of Transportation June 2012 – Federal Register Recent Federal Regulation Documents
Results 251 - 253 of 253
Airworthiness Directives; The Boeing Company Airplanes
We are adopting a new airworthiness directive (AD) for all The Boeing Company Model 777 airplanes. This AD was prompted by four reports of retaining cross bolt hardware not fully engaged into the fuse pins of the forward trunnion lower housing of the main landing gear (MLG), which could result in an incorrect MLG emergency landing break-away sequence. This AD requires a detailed inspection of the fuse pin cross bolts and fuse pins of the left and right MLG forward trunnion lower housing to verify that the cross bolts are correctly installed and that there are no missing fuse pins, and replacement of the fuse pins if necessary. We are issuing this AD to prevent an incorrect emergency landing MLG break-away sequence, which could result in puncturing of the wing box and consequent fuel leaks and an airplane fire. Failure of the fuse pins could also result in a possible landing gear collapse causing a runway excursion during take-off or landing.
Airworthiness Directives; Eurocopter Deutschland GMBH Helicopters
We are adopting a new airworthiness directive (AD) for Eurocopter Deutschland GMBH (ECD) Model MBB-BK 117 C-1 and C-2 helicopters. This AD requires installing a placard that corresponds to the maximum permissible flight altitude, amending the Rotorcraft Flight Manual (RFM) to revise the maximum permissible operating altitude, and inserting revised performance charts into the RFM. This AD also requires a repetitive maintenance ``MAX N1 CHECK'' to determine the appropriate maximum altitudes. This AD also requires, if the engine or a Fuel Control Unit (FCU) or module 2 or 3 is replaced, repeating the maintenance ``MAX N1 CHECK.'' Finally, this AD specifies that modifying both engines would provide terminating action for the AD requirements. This AD was prompted by the failure of a ``few'' engines to reach the specified one-engine-inoperative (OEI) rating at altitudes above 10,000 feet. The actions of this AD are intended to prevent flights at altitudes where the full OEI engine power cannot be reached and subsequent loss of control of the helicopter if an OEI operation is required.
Airworthiness Directives; Burkhart GROB Luft- und Raumfahrt GmbH Powered Sailplanes
We are adopting a new airworthiness directive (AD) for all Burkhart GROB Luft- und Raumfahrt GmbH Models GROB G 109 and GROB G 109B powered sailplanes. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as excessive corrosion on the nose plate in the vertical stabilizer, which could cause the vertical stabilizer nose plate to fail. We are issuing this AD to require actions to address the unsafe condition on these products.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
