Department of Transportation 2010 – Federal Register Recent Federal Regulation Documents

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2010-0098 at https://www.regulations.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with 46 U.S.C. 12121 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.

The Maritime Administration and the U.S. Coast Guard announce they have received an application for the licensing of a natural gas deepwater port and the application contains the required information. This notice summarizes the applicant's plans and procedures that will be followed in considering the application.

This amendment adopts a new airworthiness directive (AD) for the Sikorsky Model S-70A and S-70C helicopters. This AD requires an ultrasonic test (UT) inspection of the tail gearbox output bevel gear (gear) for a crack. If you find a crack, replacing the gear with an airworthy gear is required before further flight. This AD is prompted by three gear cracking incidents, one of which resulted in the tail rotor separating from the helicopter. The actions specified by this AD are intended to detect a crack in the gear to prevent a tail rotor separating, loss of tail rotor control, and subsequent loss of control of the helicopter.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD requires inspecting certain serial number (S/N) gas generator turbine (GGT) shafts for nonconforming land balance-cuts, and if found, removing the shaft from service. This AD was prompted by reports of a manufacturing quality problem. We are issuing this AD to detect nonconforming GGT shaft land balance-cuts, which could result in the shaft failing before its published life limit, and which could result in an uncontained engine failure and damage to the airplane.

We are adopting a new airworthiness directive (AD) for certain Model 777-200, -200LR, -300, and -300ER series airplanes. This AD requires removing and repairing the sealant at the four lower corners of the wing center section and the four lower t-chord segment gaps on each side of the wing center section. This AD results from reports of fuel leakage from the center tank. We are issuing this AD to detect and correct improperly applied sealant, which could result in the disbonding and displacing of sealant, and consequent fuel leaks. On the ground, uncontained fuel leakage could result in pooling, and pooling combined with an ignition source could result in a fire.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The Board hereby gives notice of 2 vacancies on RSTAC for: (1) A representative of a Class I railroad; and (2) a representative of a small shipper. The Board is soliciting suggestions for candidates to fill these vacancies.

This action proposes to amend Class E airspace at Brunswick, GA, as the McKinnon NDB Non-Directional Beacon (NDB) has been decommissioned and new Standard Instrument Approach Procedures (SIAPs) have been developed at Malcolm-McKinnon Airport. The geographic coordinates for the airport also would be adjusted. Also, reference to the Glynco Jetport would be removed from the airspace designation. This action would enhance the safety and airspace management of Instrument Flight Rules (IFR) operations at the airport.

This notice announces the availability of seven revised consensus standards to previously accepted consensus standards relating to the provisions of the Sport Pilot and Light-Sport Aircraft rule issued July 16, 2004, and effective September 1, 2004. ASTM International Committee F37 on Light Sport Aircraft developed the revised standards with Federal Aviation Administration (FAA) participation. By this notice, the FAA finds the revised standards acceptable for certification of the specified aircraft under the provisions of the Sport Pilot and Light-Sport Aircraft rule.

In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR Part 107, Subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2010-0101 at https://www.regulations.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with 46 U.S.C. 12121 and MARAD's regulations at 46 CFR part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR part 388.

In accordance with the procedures in 49 CFR Part 555, Terrafugia, Inc. (``Terrafugia''), has petitioned the agency for a temporary exemption from certain FMVSS requirements for the Transition[reg], a Light Sport Aircraft that has road-going capability. Terrafugia seeks exemption from the FMVSS requirements for tire selection and rims for motor vehicles (FMVSS No. 110), electronic stability control systems (FMVSS No. 126), glazing materials (FMVSS No. 205), and occupant crash protection, specifically advanced air bags (FMVSS No. 208). The basis for the application is that compliance would cause substantial economic hardship to a manufacturer that has tried in good faith to comply with the standard. NHTSA is publishing this notice of receipt of an application for temporary exemption and providing an opportunity to comment in accordance with the requirements of 49 U.S.C. Sec. 30113(b)(2). NHTSA has not made any judgment on the merits of the application.

FMCSA announces its decision to exempt 15 individuals from the vision requirement in the Federal Motor Carrier Safety Regulations (FMCSRs). The exemptions will enable these individuals to operate commercial motor vehicles (CMVs) in interstate commerce without meeting the prescribed vision standard. The Agency has concluded that granting these exemptions will provide a level of safety that is equivalent to, or greater than, the level of safety maintained without the exemptions for these CMV drivers.

The FAA is correcting an airworthiness directive (AD) that was published in the Federal Register. That AD applies to the products listed above. In the Information Heading and in the SUMMARY section of the published AD, we incorrectly included Cessna 188 series airplanes. In the Unsafe Condition section, we incorrectly designated that paragraph as (e) instead of (d). Also in the Compliance section, paragraph (f)(2), and in Figure 1, we incorrectly stated the mailing address for the report. We are issuing this document to help eliminate any confusion that this AD may have created in the Information Heading and in the SUMMARY and Unsafe Condition sections. This document corrects those errors. In all other respects, the original document remains the same.

This document publishes in the Federal Register an amendment adopting Emergency Airworthiness Directive (AD) 2010-18-52 which was sent previously to all known owners and operators of MD Helicopters, Inc. (MDHI) Model MD900 helicopters by individual letters. This AD requires visually inspecting the main rotor hub (hub) for a crack. If a crack is found, this AD requires, before further flight, replacing the unairworthy hub with an airworthy hub. Additionally, if a cracked hub is found, this AD requires reporting the finding to the Los Angeles Aircraft Certification Office within 10 days of finding the crack. This AD is prompted by two reports of cracks detected in the hub in the area near the flex beam bolt hole locations during maintenance on two MDHI Model MD900 helicopters. The actions specified by this AD are intended to detect a crack in the hub and prevent failure of the hub and subsequent loss of control of the helicopter.

This action modifies the Charlotte, NC, Class B airspace area to ensure the containment of aircraft, accommodate the implementation of area navigation (RNAV) departure procedures, and support operations of the third parallel runway at Charlotte/Douglas International Airport. The FAA is taking this action to improve the flow of air traffic, enhance safety, and reduce the potential for midair collision in the Charlotte, NC, terminal area.

FMCSA announces receipt of applications from 21 individuals for exemption from the prohibition against persons with insulin-treated diabetes mellitus (ITDM) operating commercial motor vehicles (CMVs) in interstate commerce. If granted, the exemptions would enable these individuals with ITDM to operate CMVs in interstate commerce.

The Department of Transportation is directing all interested persons to show cause why it should not issue an order finding Island Airlines, LLC, fit, willing, and able, and awarding it Commuter Air Carrier Authorization.

We propose to adopt a new airworthiness directive (AD) for certain Model 747-200B, -300, -400, -400D, and -400F series airplanes. This proposed AD would require an inspection to determine the part number of the door and to determine if the correct mid-pivot access door is installed, and the installation of a marker on the mid-pivot access door, and if necessary, repetitive ultrasonic inspections for cracking of the mid-pivot bolt assembly and eventual replacement of the mid-pivot bolt assembly. This proposed AD results from a report that the left and right spring beam mid-pivot bolt assembly access doors for the No. 1 strut were inadvertently installed in the incorrect position during strut modification. We are proposing this AD to detect and correct incorrectly installed mid-pivot bolt assemblies on the spring beam on the outboard struts. Incorrectly installed bolt assemblies could lead to fatigue cracking and consequent fracturing of the mid- pivot bolt assembly, which could lead to loss of the spring beam load path and the possible separation of a strut and engine from the airplane during flight.

We propose to rescind an airworthiness directive (AD) for the products listed above. The existing AD, AD 98-09-27, resulted from aircraft certification testing which revealed that stresses on the thrust reverser hinge were higher than had been anticipated during engine certification, and the United Kingdom Civil Aviation Authority, issuing AD 008-03-97. Since we issued AD 98-09-27, we discovered that its requirements were duplicated in airplane-level AD 2001-09-14, issued by the FAA Transport Airplane Directorate. This proposal to rescind the engine- level AD allows the public the opportunity to comment on the FAA's determination of the duplication of requirements in another AD, before we rescind the engine-level AD.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below is being forwarded to the Office of Management and Budget (OMB) for review and comments. A Federal Register Notice with a 60-day comment period soliciting comments on the following information collection was published on September 1, 2010 (75 FR 53733). No comments were received.

This rule establishes, amends, suspends, or revokes Standard Instrument Approach Procedures (SIAPs) and associated Takeoff Minimums and Obstacle Departure Procedures for operations at certain airports. These regulatory actions are needed because of the adoption of new or revised criteria, or because of changes occurring in the National Airspace System, such as the commissioning of new navigational facilities, adding new obstacles, or changing air traffic requirements. These changes are designed to provide safe and efficient use of the navigable airspace and to promote safe flight operations under instrument flight rules at the affected airports.

In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval for a new information collection. The Federal Register Notice with a 60-day comment period soliciting comments on the following collection of information was published on July 14, 2010, vol. 75, no. 134, page 40863. The FAA/AST will collect lessons learned from members of the commercial space industry in order to carry out the safety responsibilities in 49 U.S.C. Chapter 701 Section 70103 (c).

This action makes a minor change to the name of the using agency for restricted areas R-5301 Albemarle Sound, NC; R-5302A, B and C, Harvey Point, NC; and R-5313A, B, C and D, Long Shoal Point, NC to read ``U.S. Navy, Fleet Area Control and Surveillance Facility, Virginia Capes (FACSFAC VACAPES), Virginia Beach, VA.'' This is an administrative change only and there are no changes to the dimensions, time of designation or activities conducted within the affected restricted areas.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below is being forwarded to the Office of Management and Budget (OMB) for review and comments. A Federal Register notice with a 60-day comment period soliciting comments on the following information collection was published on September 3, 2010, in the Federal Register (75 FR, page 54215). No comments were received; however, in that notice, the Department incorrectly estimated a total of 3,329 respondents and annual burden of 756,980 hours. The Department is correcting the document as set forth below.