Department of Transportation October 2007 – Federal Register Recent Federal Regulation Documents

This notice contains a summary of certain petitions seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of any petition or its final disposition.

This notice contains a summary of a petition seeking relief from specified requirements of 14 CFR. The purpose of this notice is to improve the public's awareness of, and participation in, this aspect of FAA's regulatory activities. Neither publication of this notice nor the inclusion or omission of information in the summary is intended to affect the legal status of the petition or its final disposition.

This rule modifies Class D airspace at Castle Airport, Atwater, CA. This action lowers the ceiling of the Atwater, Castle Class D airspace to below 2.000 feet mean sea level (MSL), changes the southern boundary of the airspace and add an extension to the north. FAA is taking this action to provide controlled airspace for the safety of aircraft executing Standard Instrument Approach Procedures (SIAPs) and other Instrument Flight Rules (IFR) operations at Castle Airport. Except for editorial changes, this rule is the same as the Notice of Proposed Rule Making.

We are revising an earlier NPRM for the products listed above. This action revises the earlier NPRM by expanding the scope. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA proposes to adopt a new airworthiness directive (AD) for various transport category airplanes. This proposed AD would require deactivation of Rogerson Aircraft Corporation auxiliary fuel tanks. This proposed AD results from fuel system reviews conducted by the manufacturer, which identified potential unsafe conditions for which the manufacturer has not provided corrective actions. We are proposing this AD to prevent the potential of ignition sources inside fuel tanks, which, in combination with flammable fuel vapors, could result in fuel tank explosions and consequent loss of the airplane.

The FAA proposes to supersede an existing airworthiness directive (AD) for Rolls-Royce plc (RR) RB211-535E4-37, RB211-535E4-B- 37, and RB211-535E4-B-75 series turbofan engines. That AD requires initial and repetitive ultrasonic inspections of installed low pressure compressor (LPC) fan blade roots on-wing and during overhaul, and relubrication according to accumulated life cycles. That AD also introduces an alternative technique to ultrasonically inspect installed fan blades on-wing using a surface wave ultrasonic probe. Also, that AD introduces application of Metco 58 blade root coating as an optional terminating action. This proposed AD would require the same actions but would add compliance paragraphs to relax the compliance schedule for repetitive inspections for RB211-535E4 engines operating in flight profiles A and B, if certain requirements are met. This proposed AD results from RR issuing Mandatory Service Bulletin (MSB) No. RB.211-72- C879, Revision 5. That MSB introduces a relaxed repetitive compliance schedule for RB211-535E4 engines operating in flight profiles A and B, if certain requirements are met. We are proposing this AD to detect cracks in LPC fan blade roots, which if not detected, could lead to uncontained multiple fan blade failure, and damage to the airplane.

In accordance with the Paperwork Reduction Act of 1995, FMCSA announces its plan to submit the Information Collection Request (ICR) described below to the Office of Management and Budget (OMB) for review and approval. This information collection concerns the requirement that companies holding permits for transporting certain hazardous materials to develop a communications plan that allows for the periodic tracking of the shipment. A record of the communications may be kept by either the driver (e.g., recorded in the log book) or the company that contains the time of the call and location of the shipment. These records must be kept, either physically or electronically, for at least six months at the company's principal place of business or readily available to employees at the company's principal place of business. On July 20, 2007, FMCSA published a Federal Register notice allowing for a 60-day comment period on the ICR. One comment was received.

Under this notice, the FAA announces that New York's John F. Kennedy International Airport (JFK) has been designated a Level 3 Coordinated Airport for the summer 2008 scheduling season in accordance with the International Air Transport Association (IATA) Worldwide Scheduling Guidelines. This notice supercedes the September 24, 2007, notice that designated JFK a Level 2 Schedules Facilitated Airport. 72 FR 54317. Based on a recently completed capacity analysis, a review of last summer's demand, the projections for summer 2008, and the agency's decision to seek voluntary schedule reductions from domestic air carriers, the FAA has determined that a Level 3 airport declaration is warranted. The primary coordination constraint is runway/air traffic control capacity. JFK is experiencing increased congestion and delay. Comparing the period of October 2006 through July 2007 to the same period in the previous year, the average daily operations at JFK increased 23 percent; the average daily arrivals with delays greater than one hour increased 114 percent; and on-time gate arrivals within 15 minutes of scheduled time decreased from 69.7 percent to 61.2 percent. The average taxi-out delay increased 19 percent from 30 to almost 36 minutes. On- time departures within 15 minutes of scheduled time declined from 74.7 percent to 65.2 percent. Much of this delay is attributed to volume and is not likely to be entirely mitigated by short-term air traffic control procedural enhancements, airport or airspace efficiency gains, or airport infrastructure changes. For example, from February 2007 through July 2007, JFK's average airport capacity was 81 operations per hour while demand during the busiest hour, 4 p.m., was over 110 scheduled arrivals and departures during summer 2007. Adjacent hours had fewer scheduled flights but still above the average hourly capacity rate. Under a preliminary review of the schedule submissions for summer 2008, the FAA notes that there are proposed schedule increases by domestic carriers and foreign flag carriers. These proposed schedules will result in a significant increase of operations at JFK. While JFK has available capacity for additional flights during some periods of the day, certain hours are currently beyond capacity and would get only worse if the schedules were implemented as proposed. Thus, based on the level of congestion experienced this past summer season, the planned increases for next summer, and the decision to seek voluntary reductions of existing schedules from domestic operators through a scheduling reduction meeting,\1\ an immediate Level 3 designation is warranted.

The FAA publishes a monthly notice, as appropriate, of PFC approvals and disapprovals under the provisions of the Aviation Safety and Capacity Expansion Act of 1990 (Title IX of the Omnibus Budget Reconciliation Act of 1990) (Pub. L. 101-508) and Part 158 of the Federal Aviation Regulations (14 CFR Part 158). This notice is published pursuant to paragraph (d) of Sec. 158.29.

We propose to adopt a new airworthiness directive (AD) for certain Cessna Aircraft Company (Cessna) Models 172R and 172S. This proposed AD would require you to inspect the fuel return line assembly for chafing; replace the fuel return line assembly if chafing is found; and inspect the clearance between the fuel return line assembly and both the right steering tube assembly and the airplane structure, adjusting as necessary. This proposed AD results from reports of chafed fuel return line assemblies, which were caused by the fuel return line assembly rubbing against the right steering tube assembly during full rudder pedal actuation. We are proposing this AD to detect and correct chafing of the fuel return line assembly, which could result in fuel leaking under the floor and fuel vapors entering the cabin. This condition could lead to fire under the floor or in the cabin area.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is adopting a new airworthiness directive (AD) for GE CF6-80C2D1F turbofan engines, installed on, but not limited to, McDonnell Douglas Corporation MD-11 series airplanes. This AD requires removing previous software versions from the engine electronic control unit (ECU). Engines with new version software will have increased margin to flameout. This AD results from reports of engine flameout events during flight, including reports of events where all engines simultaneously experienced a flameout or other adverse operation. Although the root cause investigation is not yet complete, we believe that exposure to ice crystals during flight is associated with these flameout events. We are issuing this AD to minimize engine flameout caused by ice accretion and shedding during flight.

The FAA is adopting a new airworthiness directive (AD) for certain McDonnell Douglas airplanes, identified above. This AD requires a one-time inspection to determine the configuration of the airplane. This AD also requires repetitive inspections for cracking of the tee or angle doubler, and corrective actions if necessary. This AD results from a report indicating that numerous operators have found cracks on the tee. We are issuing this AD to detect and correct stress corrosion cracking of the tee or angle doubler installed on the flat aft pressure bulkhead. Cracking in this area could continue to progress and damage the adjacent structure, which could result in loss of structural integrity of the airplane.

The OST invites public comments about our intention to request the Office of Management and Budget's (OMB) approval for renewal of a previously approved information collection that is summarized below under SUPPLEMENTARY INFORMATION. We are required to publish this notice in the Federal Register by the Paperwork Reduction Act of 1995.

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is issuing this notice to advise the public of a meeting of RTCA Special Committee 207, Airport Security Access Control Systems.

This document announces receipt by the National Highway Traffic Safety Administration (NHTSA) of a petition for a decision that 2000-2001 Moto Guzzi California motorcycles that were not originally manufactured to comply with all applicable Federal motor vehicle safety standards (FMVSS) are eligible for importation into the United States because (1) they are substantially similar to vehicles that were originally manufactured for sale in the United States and that were certified by their manufacturer as complying with the safety standards, and (2) they are capable of being readily altered to conform to the standards.

This document announces receipt by the National Highway Traffic Safety Administration (NHTSA) of a petition for a decision that 1993 Ducati 888 motorcycles that were not originally manufactured to comply with all applicable Federal motor vehicle safety standards (FMVSS) are eligible for importation into the United States because (1) they are substantially similar to vehicles that were originally manufactured for sale in the United States and that were certified by their manufacturer as complying with the safety standards, and (2) they are capable of being readily altered to conform to the standards.

This document announces receipt by the National Highway Traffic Safety Administration (NHTSA) of a petition for a decision that 1999-2007 Yamaha Drag Star 1100 motorcycles that were not originally manufactured to comply with all applicable Federal motor vehicle safety standards (FMVSS) are eligible for importation into the United States because (1) they are substantially similar to vehicles that were originally manufactured for sale in the United States and that were certified by their manufacturer as complying with the safety standards, and (2) they are capable of being readily altered to conform to the standards.

This document announces receipt by the National Highway Traffic Safety Administration (NHTSA) of a petition for a decision that 1988 Ducati 851 motorcycles that were not originally manufactured to comply with all applicable Federal motor vehicle safety standards (FMVSS) are eligible for importation into the United States because (1) they are substantially similar to vehicles that were originally manufactured for sale in the United States and that were certified by their manufacturer as complying with the safety standards, and (2) they are capable of being readily altered to conform to the standards.