Department of Transportation July 23, 2007 – Federal Register Recent Federal Regulation Documents
Results 1 - 2 of 2
Airworthiness Directives; McDonnell Douglas Model DC-10-10, DC-10-10F, DC-10-30F (KC-10A and KDC-10), DC-10-40F, MD-10-10F, and MD-10-30F Airplanes; and Model MD-11 and MD-11F Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain McDonnell Douglas Model DC-10-10, DC-10-10F, DC-10-30F (KC- 10A and KDC-10), DC-10-40F, MD-10-10F, and MD-10-30F airplanes; and Model MD-11 and MD-11F airplanes. This proposed AD would require installation of control cable freeze protection by making certain changes. This proposed AD results from reports of standing water on the horizontal pressure panel above the main and center landing gear wheel wells. We are proposing this AD to prevent the accumulation of ice on the flight control cables in the wheel wells. When the landing gear doors open or vibration in this area occurs, such ice accumulation could break off and can cause injury to people or damage to property on the ground, can affect landing gear controls and rear spar flight control systems, can cause damage to other control systems, and might cause loss of control of the airplane.
Airworthiness Directives; McDonnell Douglas Model DC-10-10, DC-10-10F, DC-10-15, DC-10-30 and DC-10-30F (KC-10A and KDC-10) Airplanes; Model DC-10-40 and DC-10-40F Airplanes; and Model MD-11 and MD-11F Airplanes
The FAA is revising an earlier proposed airworthiness directive (AD) for certain McDonnell Douglas Model DC-10-10, DC-10-10F, DC-10-15, DC-10-30 and DC-10-30F (KC-10A and KDC-10) airplanes; Model DC-10-40 and DC-10-40F airplanes; and Model MD-11 and MD-11F airplanes. The original NPRM would have required, for certain airplanes, modifying the thrust reverser command wiring of the number 2 engine. For certain other airplanes, the original NPRM would have required modifying the thrust reverser system wiring from the flight compartment to engines 1, 2, and 3 thrust reversers. The original NPRM also would have required installing thrust reverser locking systems on certain airplanes. The original NPRM resulted from a determination that the thrust reverser systems on these McDonnell Douglas airplanes do not adequately preclude unwanted deployment of a thrust reverser. This action revises the original NPRM by revising, for certain airplanes, the requirements for the modification of the thrust reverser system wiring from the flight compartment to engines 1, 2, and 3 thrust reversers. We are proposing this supplemental NPRM to prevent an unwanted deployment of a thrust reverser during flight, which could result in reduced controllability of the airplane.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.